$ (-pr + &

The data were interpreted in terms of a com- petition between protonation of a carbanion-electrode complex from the rear and protonation of the carban...
16 downloads 0 Views 252KB Size
NOTES 1283

Vol. 33, No. 3, March 1968 Stereoselective Electrochemical Reduction of Geminal Dihalocyclopropanes ALBERTJ. FRYAND RICHARD H. MOORE Chemistry Department, Weskyan University, Middletawn. Connecticut 06467 Received September 19, 1967

A recent study’ of the stereochemistry of electrochemical reduction of optically active 1-bromo-2,2diphenylcyclopropylcarboxylic acid and derivatives of the acid demonstrated a stereochemical spectrum ranging from 56% inversion to 38% retention of configuration. The data were interpreted in terms of a competition between protonation of a carbanion-electrode complex from the rear and protonation of the carbanion in solution. The present report demonstrates both stereochemical discrimination by the electrode between two possible sites for electroreduction and a solvent effect upon stereoselectivity of the reduction; the data are summarized in Table I.

la, n = 4; X =Br

2 (major)

3

b,.n= 4; X = C1 c , n = 6; X=Br

$ H Id

Br

(-pr & +

H

2d

H 3d

In terms of a mechanistic scheme previously advanced by Annino, et aLll for electrochemical reductions of monohalocyclopropanes, there are two alternate explanations for the stereoselective formation of the less stable isomers 2a-d. Either the “outside” halogen (cisto the two hydrogens at the ring junction) is reduced with retention of configuration, or the “inside” halogen is reduced, with inversion of configuration. We prefer the first course, for the following reasons. Assuming a substrate-electrode geometry in which the carbonhalogen bond is either parallel to the electrode surface or TABLE I in which the bromine is nearest the electrode,’J steric STEREOCHEMISTRY I N CONTROLLED POTENTIAL ELECTROLYSIS repulsions are far greater in the transition state for OF DIHALOCYCLOPROPANES reduction of the (‘inside’’halogen. If, then, reduction of Relative % of the “outside” halogen is involved, it is necessary to -productscpostulate that the initially formed halocyclopropyl Expt Substrate Solvent 2 3 carbanion must diffuse into solution and be protonated 1 la 100% DMFa 61 39 before it can lose much, or any, of its configuration. 2 la 96% D M F 4 % HZO 75 25 Experiment 12 is consistent with this interpretation. 66 34 3 la 100% CHaOH Sternberg, et al.,s have demonstrated that the solvent 4 la 95% CHsOH-5% HzO 73 27 system 33 mol % hexamethylphosphoramide (HMPA)5 la 95% CHsOH-5% HClb 78 22 6 la 90% CHsOH-lO% HzO 84 16 67% EtOH provides an effectively aprotic region at the 7 la 100% HOAC 80 20 electrode surface, presumably because of preferential 8 lb 100% DMF 81 19 adsorption of the highly polar HMPA. Even though 9 Ib 96% D M F 4 % Hz0 84 16 the carbanion in expt 12 must move away from the 10 1b 100% CHsOH 95 5 electrode, therefore, to seek a proton, the stereochemis11 1b 95% CHsOH-5% HCI 100 0 try of reduction is the same as in the other runs. Re12 Ib 33% HMPAd-67% EtOH 100 0 duction of the ‘(inner” halogen would require subse13 IC 100% CHsOH 100 0 sequent isomerization to a less stable anion before 14 IC 95% CHsOH-5% HC1 100 0 protonation. 15 Id 1007, CHsOH 73 27

16 Id 90% CHaOH-10% Hz0 91 9 DMF = dimethylformamide. b 95% methanol-5% concentrated aqueous hydrochloric acid. c Precision of results +3% after a minimum of five integrations per sample. d HMPA = hexamethyl phosphoramide. (I

The major product in all electrochemical reductions of geminal dihalocyclopropanes la-d is the cis isomer 2, and in solvents of higher water content the proportion of 2 is increased (e.g., expt 1and 2 or 3 and 4). Because of limited solubility of the geminal dihalides in more highly aqueous solvents, a wide range of solvent compositions was not investigated. I n view of this and the fact that the solvents differ in a number of properties, including proton-donating ability and dielectric constant, detailed discussion of trends would be speculative. The synthetic advantage in increasing the stereoselectivity by use of a more highly aqueous solvent is apparent, however (cf. expt 15 and 16). (1) R. Annino, R. E. Erickson, K. Miohalovio, and B. McKey, J . Amer. Chem. Soc., 86, 4424 (1966).

Experimental Section4 Dihalocyclopropanes (la-d) were prepared according to published procedure^.^-^ General.-Electrolyses were carried out in a divided cell of conventional design’ equipped with platinum gauze anode and magnetically stirred mercury pool cathode and immersed in an ice bath. The reference electrode was a silver wire immersed in saturated aqueous potassium chloride in a Fisher Remote Reference Junction and positioned 1 mm from the cathode surface. Cathode potentials were controlled by a solid-state potentiostat to be described elsewhere. (2) J. W . Sease, P. Chang, and J. L. Groth, ibid., 86, 3154 (1964). (3) H. W, Sternberg, R. E. Markby. I. Wender, and D. M. Mohilner, ibid., 89, 186 (1967). (4) Nmr spectra were measured on a Varian A-60A spectrometer. Solvents were reagent grade used without further purification. Vapor phase chromatography (VPC)was carried out on a Varian Aerograph Model P-3 instrument using 10% Carbowax on Fluoropak. (5) D. Seyferth, J. M. Burlitch, and J. K . Heeren, J . 01.0.Chem., 97, 1491 (1962). (6) W. von E. Doering and A. K. Hoffmann, J . Amer. Chem. SOC..76, 6164 (1954). (7) 8. Winstein and J. Sonnenberg, ibid.. 88, 3235 (1961). (8) L. Meitea in “Technique of Organic Chemistry,” Vol. 1, A. Weissberger, Ed., Interscience Publishers, Inc., New York, N. Y., 1960, p 3297.

The Journal of Organic Chemistry

1284 NOTES Electrolyses.-A 1 M solution of lithium chloride (50 ml) in the appropriate solvent was placed in the cathode compartment; the anolyte wm identical, but also contained 5 ml of 95% hydrazine. The solvent waa purified by pre-electrolysis in a nitrogen stream for 30 min at a cathode potential of - 1.1 V us. Ag-AgC1 for la, C, and d, and -2.0 V for lb. The dihalide (5-7 mmol) was added and electrolysis wm allowed to proceed until current had decayed to background. The catholyte was poured into water, extracted with pentane, washed with water, and dried over magnesium sulfate. The pentane was carefully distilled; the 2-3 mixtures were analyzed by nmr spectroscopy by the method of Seyferth, et a2.O Results generally agreed with results of independent vpc analws. Yields of halocyclopropaneswere in the range SO-SO%.

Registry No.-la, 15649-61-3; IC, 15649-58-8; Id, 15834-79-4.

-

carbethoxymethyl dimethylsulfonium bromide with anhydrous potassium carbonate.

+ 3CHz=CH--C02Et

EtO&-CH&CH&Br-

KZCOI

3

Ethyl crotonate and EDSA afforded a 75% yield of diethyl 3-methylglutaconate (4) as a 50:50 mixture of cis-trans isomers while EDSA and diethyl fumarate gave triethyl aconitate (5) in 87% yield as a 70: 30 mixture of trans-cis isomers. CH:

1

lb, 15649-62-4;

I + CHsCH=CHCOzEt +EtOzC--CH=C-CH&O&t 4

COzEt

Acknowledgment.-Financial support by the Petroleum Research Fund is gratefully acknowledged. (9) D. Seyferth, H. Yamasaki, and D. L. Alleston, J . O w . Chsm., 48, 703 (1963).

Ethyl (Dimethylsulfurany1idene)acetate. 11. Reactions with a,@-UnsaturatedEsters in Ethanol Solutions GEORQEB. PAYNE

1

I + EtOzCCH=CHCO%Et+EtO~G-CEI=G--CH&O~Et 5

Compound 2 was identified by elemental and nmr analyses and by hydrogenation followed by saponification to the known 1,3,5-pentanetricarboxylic acid. Structure 3 was assigned on the basis of elemental and nmr analyses. Saponification of 4 gave the known 3-methylglutaconic acid as a mixture of cistrans isomers, and 5 was identified by comparison with an authentic sample of triethyl aconitate. The formation of 2 has been rationalized according to Scheme I.

Shell Development Company, Emeryvilk, Californiu 1

Received OCtObeT 10,1967

The general reaction between ethyl (dimethylsulfurany1idene)acetate (EDSA, 1) and a#-unsaturated compounds in aprotic solvents to produce substituted cyclopropanes was recently reported.' We now report that reaction of EDSA with certain @-unsaturated esters in ethanol solution leads not to cyclopropanes but rather to open-chain products of varying complexity. Results and Discussion Reaction of EDSA with 4 molar equiv of ethyl acrylate in ethanol at 30-35' afforded a 69% yield (based on EDSA) of triethyl 2-pentene-1,3,5-tricarboxylate(2) along with a 20% yield of triethyl 3-(2-ethoxycarbonylethyl)-l-pentene-1,3,5-tricarboxylate (3). Tetraester

A

+ CH-CH-z

H + shift

(ylide formation)

1

Z-&(CHz)zZ

CHz=C H-2

-+

1

*(C&)Z '

I

Z-C-CH~-~H-Z I n z =

H + shift

---+ 2 -(CHdzS

coat

Compound 3 can be visualized as being formed via intermediates A and B by Michael reaction of the latter with 2 mol of ethyl acrylate. A

H + shift

-(CHI) zS

RCH=CHZ

C02Et

I

C02Et I E tO&-CH4H-&(CH&H,C02Et)~ 3

3 was subsequently prepared in 40% yield as the sole product obtained from ethyl acrylate and EDSA when the latter was generated slowly in situ by reaction of (1) G.B. Payne, J. Or& Chem.. SP, 3351 (1967).

+S(CHsh A

(CH2)zZ

I--.----,

2

-+ Z-CH-CH~-EH-Z I

PCHz=CH-Z

Z-CH=CH-CHz-Z B

3

The conversions of ethyl crotonate into 4 and diethy1 fumarate into 5 are believed to occur by the same mechanism.

EtO&-CH=S(CH&

EtO.&CHZ)zC=CH-CH&O2Et

SCHEME In

[

R

I

Z-CH--CH--CH-Z

d(CH,)p

1

H + shift

--+

- (CHa)zS

4, R = 5, R =

CHP COpEt

Experimental Section* Reaction of EDSA with Ethyl Acrylate.-To a solution of 20.0 g (0.20 mol) of ethyl acrylate in 50 ml of absolute ethanol was (2) Melting point8 are corrected; boiling points are uncorrected. Nmr spectra were obtained in CDCli with a Varian A-60 spectrometer using tetramethylsilane as an internal standard. Glpc analyses were done with a n F & M Model 720 instrument using a column packed with 5% of XF-1160 on Chromoaorb W.