A Simple Micro-Mull Technique for Obtaining Infrared Spectra

Chem. , 1962, 34 (3), pp 448–448. DOI: 10.1021/ac60183a051. Publication Date: March 1962. ACS Legacy Archive. Cite this:Anal. Chem. 34, 3, 448-448...
2 downloads 0 Views 114KB Size
marker is actuated b y a single-pole switch placed in the fraction collector in such a position that i t is depressed by a cam in the motor-drive assembly when the collection tube is changed. A 110-volt relay attached to the motor terminals could also be used. It is felt that the 6-volt circuit employed here minimizes any shock hazard which might arise at connection points along the extension to the event-marker sm-it ch .

For use, the unit containing the light source and photocell is laid on its side and the flow-cell holder and cell are inserted. I t is convenient t o attach a

light spring between the base and the arm holding the photocell, t o hold the cell holder tightly in place. With solvent in the cell and the light shutter closed, 0% transmittance is set first on the transmittance density unit and then on the recorder. Then, lOO%T is adjusted first on the transmittance density unit, using the iris diaphragm in front of the photocell, and then on the recorder using the voltage attenuator. The germicidal lamp ultraviolet light source provided with the Photovolt emits most of its energy as the 2537-A. mercury line. When used in conjunction with the Photovolt 5265 filter, this

provides a fairly monochromatic light source. A semilog plot of %T us. concentration of benzophenone in 95% alcohol (absorption masinium 253 mk) is linear down to about 25% T . h p parently enough longer wavelength light passes through the filter to cause deviation from linearity a t higher concentrations of benzophenone. This is not serious if the unit is used only as a locating device. -4 similar plot for Citrus Red KO. 2 in 95% alcohol (absorption maximum 515 mp) obtained with a visible light source and a 525-mp glass filter is linear to less than 20% T. The results are shown in Figure 3.

A Simple Micro-Mull Technique for Obtaining Infrared Spectra C. Szonyi and J. D. Craske, Unilever Australia Pty. Ltd., Balmain, Australia

I

of paraffin mulls of solid compounds may give in some cases more detailed information than those of solutions. Normally, 10 to 20 mg. of sample is required if the mull is prepared by mixing the solid compound with paraffin oil in a small mortar until a smooth paste is obtained. This can be reduced t o 5 to 7 mg. by careful work. Lohr and Kaier ( 2 ) described a special micro-mulling technique whereby the required sample amount was reduced to about 3 to 5 mg. Techniques for spectroscopic investigation of 0.1 mg. and even 5 p g . of solids have been published (1, 3 ) . but these, however, require a beam condenser and/or a microscope attachment on the spectrophotometer. A micro-mull method has been developed in this laboratory, which requires only 0.3 to 0.5 mg. of sample and n hich is directly applicable to industrial infrared spectrophotometers tvithout the need to construct any special apparatus. I n the present iyork, a Perkin-Elmer Infracord Model 137 spectrophotometer vias used. The size of the rock salt 11indon s usrd is 6 X 22 mm. -4 droplet of paraffin oil (about 0.005 ml.) is placed on one of the rock salt plates from a microsyringe. The solid compound is dissolved in a volatile solvent to yield an 0.5 approximatrly 1% solution-e.g., mg. in 0.05 ml. Using a microsyringe, about 0.05 nil. of the solution is then transferred drop$& to the oil droplet, allowing time for the solvent to evaporate after application of each drop, so that a mixture of the solid and paraffin oil remains on the plate. This mixture is then homogenized by pressing a second rock salt plate on top of NFRARED SPECTRA

448

ANALYTICAL CHEMISTRY

Micro-mull method (0.5 mg,)

Figure 1. Infrared spectra of n-decanal 2,4-dinitrophenylhydrazone

Macro-mull method

I I I I 6 7 0 9 Wavelength (Microns)

the first. The spectra obtained by this method are equivalent to those of paraffin mulls prepared by the normal macro-technique. See Figure 1. ACKNOWLEDGMENT

The authors thank the Directors of

I 10

I 11

I

I

12

13

I 14

Cnilever dustralia Pty. Ltd. for permission to publish this note. LITERATURE CITED

(1) Clark, D. A, Boer, A. P., Spectrochinz. Acta 12, 276 (1958). ( 2 ) Lohr, L. J., Kaier, R. J., ANAL.CHEW 32, 301 (1960). ( : 3 ) Star-art, J . E., Ihid., 31, 1287 (1959).