Correction to “Tuning the Performance of Low-Pt Polymer Electrolyte

Addition/Correction pubs.acs.org/JPCC

Correction to “Tuning the Performance of Low-Pt Polymer Electrolyte Membrane Fuel Cell Electrodes Derived from Fe2O3@Pt/C Core−Shell Catalyst Prepared by an in Situ Anchoring Strategy” Vishal M Dhavale and Sreekumar Kurungot* J. Phys. Chem. C 2012, 116 (13), 7318−7326. DOI: 10.1021/jp300628j

I

t has been brought to our attention that there is a mistake in our recently published paper J. Phys. Chem. C 2012, 116, 7318−7326. On page 7320, the high-resolution transmission electron microscopy image in Figure 1c is not correct. The

Figure 1. TEM images of (a) Fe2O3@Pt/C well-dispersed core−shell nanoparticles on the surface of the carbon support and (b) Fe2O3@Pt/ C core−shell nanoparticles clearly showing the boundaries of the core and shell regions of the nanoparticles, where the inset shows the particle size histogram of Fe2O3@Pt/C nanoparticles, indicating an average particles size of ∼3−5 nm. (c) HR-TEM image of a single particle showing the lattice mismatch at the edge of the core and shell region. (d) SAED pattern.

correct image in the figure is given here. Unfortunately, we did not identify this mistake while proof reading the manuscript, and we sincerely apologize for any confusion this error may have caused.

Published: May 25, 2012 © 2012 American Chemical Society

12377

dx.doi.org/10.1021/jp3045803 | J. Phys. Chem. C 2012, 116, 12377−12377