It is not necessary to use a Nal(Tl) well detector to de- termine the Kn factor. Any method of analysis that would determine any convenient element pr...
The method involves determining a normal- izing factor which relates the geometry and dead time between standard and sample. National Bureau of Stan-.
Jun 19, 2008 - Departamento de Automação e Sistemas, UniVersidade Federal de ... Brazil, and Departamento de IngenierÃa de Sistemas y Automática, ...
Following filtration at 5° C., the wet cake ofquinacrine hydro- chloride crystals was slurried with acetone to facilitate removal of the remaining hydrochloric acid ...
Jan 12, 2005 - Correction - Empirical Correction for Compressibility Factor and Activity Coefficient Curves. Ralph Morgan, and J. Childs. Ind. Eng. Chem.
Oct 6, 2017 - ... the as-quenched OFF state which takes place within the dead time after a reset operation. Our results demonstrate the technological relevance of the dead time rule which enables a zero bias access of both the low and high resistance
Oct 6, 2017 - The resistive switching behavior in SiOx-based phase change memory devices confined by few nanometer wide graphene nanogaps is investigated. Our experiments and analysis reveal that the switching dynamics is not only determined by the c
Oct 6, 2017 - We demonstrate that an internal time scale, the dead time, plays a ... View: ACS ActiveView PDF | PDF | PDF w/ Links | Full Text HTML.
Oct 6, 2017 - Department of Physics, University of Basel, Klingelbergstrasse 82, ... Swiss Nanoscience Institute, University of Basel, CH-4056 Basel, ...
Oct 6, 2017 - Along the breakdown process short (500 μs) voltage pulses were applied, each followed by a low bias resistance (Rlow) measurement using a 5 ms pulse with Vlow = 100 mV amplitude. These pulse sequences were repeated with 100 ms period g
and copper as ultratrace contaminants. Iron was not detectable in 4 liters of distilled-deionized water (
