Characterization of Sulfur Speciation in Low ... - ACS Publications

Keywords: LMW subunits of glutenin; X-ray absorption near-edge structure (XANES) spectroscopy; quantitative analysis; sulfur K-edge; wheat gluten...
0 downloads 0 Views 155KB Size
J. Agric. Food Chem. 2003, 51, 7431−7438

7431

Characterization of Sulfur Speciation in Low Molecular Weight Subunits of Glutenin after Reoxidation with Potassium Iodate and Potassium Bromate at Different pH Values Using X-ray Absorption Near-Edge Structure (XANES) Spectroscopy ALEXANDER PRANGE,*,† BARBARA BIRZELE,† JOHANNES KRA¨ MER,† HARTWIG MODROW,‡ REINHOLD CHAUVISTREÄ ,‡ JOSEF HORMES,§ AND PETER KO¨ HLER# Institute for Plant Diseases, Department of Agricultural and Food Microbiology, University of Bonn, Meckenheimer Allee 168, D-53115 Bonn, Germany; Institute of Physics, University of Bonn, Nussallee 12, D-53115 Bonn, Germany; The J. Bennett Johnston, Sr., Center for Advanced Microstructures and Devices (CAMD), Louisiana State University, 6980 Jefferson Highway, Baton Rouge, Louisiana 70806; and German Research Center for Food Chemistry, Lichtenbergstrasse 4, D-85748 Garching, Germany

Sulfur speciation in low molecular weight (LMW) subunits of glutenin after reoxidation with potassium iodate and potassium bromate at different pH values, aged subunits of glutenin as well as gluten, and gliadin have been investigated in situ by S K-edge X-ray absorption near-edge structure (XANES) spectroscopy. XANES spectra were analyzed quantitatively using a least-squares fitting routine to provide relative percentage contribution of different sulfur species occurring in the samples. Using potassium iodate and potassium bromate for reoxidation of reduced LMW subunits of glutenin led not only to disulfide states but also to higher oxidation states (sulfoxide state, sulfonic acid state). Strongest oxidation occurred at low pH values. Higher oxidation states were also predominantly detected in the aged subunits of glutenin, whereas the disulfide state was the main sulfur species in gluten and gliadin samples. The results showed that the oxidation state of sulfur prior to oxidation (thiol, disulfide) strongly influences sulfur speciation after oxidation. The choice of the oxidizing reagent seems to be of minor importance. KEYWORDS: LMW subunits of glutenin; X-ray absorption near-edge structure (XANES) spectroscopy; quantitative analysis; sulfur K-edge; wheat gluten

INTRODUCTION

Gluten proteins mainly determine the functional properties of doughs and the baking quality of wheat. They have been classified into sulfur-rich, sulfur-poor, and high molecular weight (HMW) groups by their molecular weight and amino acid sequences (1). The R- and γ-gliadins and the low molecular weight (LMW) subunits of glutenin (B- and C-types) form the first group (sulfur-rich) and the ω-gliadins and the D-type LMW subunits of glutenin the second group (sulfur-poor) (1, 2). Cysteine-containing components are able to form HMW aggregates linked by intermolecular disulfide bonds and have thus a key role for functionality of doughs. Whereas ∼95% of * Corresponding author [e-mail [email protected]; telephone ++49 (0)228 737719; fax ++49 (0)228 739592]. † Institute for Plant Diseases, Department of Agricultural and Food Microbiology, University of Bonn. ‡ Institute of Physics, University of Bonn. § Louisiana State University. # German Research Center for Food Chemistry.

the cysteine residues of gluten protein compounds occur as interor intramolecular disulfides in freshly prepared flour, only 5% appear in the thiol form (2, 3). Sulfur in the thiol form might catalyze thiol-disulfide exchange reactions during dough mixing. In the gluten network, elasticity is determined by intermolecular disulfide bonds within the glutenins, whereas viscosity is determined by the monomeric gliadin fraction, containing exclusively intramolecular disulfide bonds. In particular, the number and the amount of subunits belonging to the LMW group (B- and C-type LMW subunits of glutenin) are correlated significantly with the extensibility of doughs as shown by extensograph measurements (4). The influence of sulfur fertilization on bread-making quality was published recently showing that application of sulfur reduced the dough resistance and increased the extensibility (5). The total cysteine content of gluten protein components can be determined by amino acid analysis, for example, after oxidation with performic acid, but a distinction between cysteine and cystine is not possible by this method (6). Free SH and SS

10.1021/jf034457e CCC: $25.00 © 2003 American Chemical Society Published on Web 10/17/2003

7432

J. Agric. Food Chem., Vol. 51, No. 25, 2003

groups can be determined spectrophotometrically prior to and after reduction according to the methods of Ellman (7) and Henschen (8). The identification and localization of cysteine and cystine residues are, however, only possible after labeling of SH groups and subsequent partial enzymatic hydrolysis of gluten proteins and sequence analysis of the relevant peptides (6, 9). The most important disadvantage of all these methods is the limited information about the oxidation state of sulfur as only the SH and SS forms can be determined and structural changes may have occurred. Therefore, X-ray absorption near-edge structure (XANES) spectroscopy at the sulfur K-edgesas an in situ methodswas applied to characterize the speciation of sulfur in gluten proteins on the basis of native samples. XANES spectroscopy at the sulfur K-edge using synchrotron radiation is an excellent tool to investigate the speciation of sulfur in biological samples (10-13). A more detailed insight into the method (including theoretical and technical details) and a topical overview over the broad range of scientific questions of biological, environmental, and agricultural research that were recently tackled and investigated using X-ray absorption spectroscopy are provided by Prange and Modrow (14). A main advantage of XANES spectroscopy is that the method is nondestructive and measurements can be conducted in situ. It allows the determination of the valence of an excited atom and of the electronegativity of neighboring atoms (15). Because ab initio calculations of the XANES region are complicated and reliable results are still difficult to obtain, structural information is often deduced by a “fingerprint method”. The near-edge spectrum of the sample to be analyzed is compared with those of suitable model compounds yielding “qualitative information”. The successful application of XANES spectroscopy as a fingerprint method has been demonstrated (16, 17). However, to describe spectral features quantitatively, a “quantitative analysis” can also be performed. The fact that only the local environment of the absorbing atoms is probed implies that the spectrum of a mixture of substances A and B can be composed from the spectra A and B measured separately. This additivity is the basis for the quantitative analysis of XANES spectra, which means the decomposition of a sum spectrum into its components. A “quality function” defined by the difference between experimental data and a linear combination of spectra contained in a basis set can be minimized to achieve the decomposition of the sum spectrum (e.g., refs 12 and 18). A detailed verification and successful application of the quantitative analysis can be found, for example, in refs 12 and 19 using defined mixtures of different sulfur substances. By using XANES spectroscopy as a fingerprint method and by comparing the obtained spectra with those of reference compounds, we recently found evidence for the presence of higher oxidation states (sulfoxide, sulfonate) in LMW and HMW subunits of glutenin reoxidized with potassium bromate at pH 2 and in glutenin subunits stored under ambient air and temperature conditions (20). Potassium bromate and potassium iodate, which have a positive effect on the dough structure after mixing, have been widely used for breadmaking, especially in the United States and the United Kingdom (21-23). It is accepted that these oxidizing agents promote the oxidation of cysteine to the disulfide state (24, 25). The presence of oxidation states higher than disulfide, however, is not in accordance with the traditional point of view (26). To clarify the occurrence of higher oxidation states and their amounts in reoxidized subunits of glutenin by potassium bromate and potassium iodate in

Prange et al. subordination to different pH values, the present study aimed at providing a quantitative description of the sulfur speciation using a least-squares fitting routine to determine possible contributions of different reference compounds to the XANES spectra. MATERIALS AND METHODS LMW and HMW Subunits of Glutenin. LMW and HMW subunits of glutenin were extracted from the cultivar Rektor using a modified method according to Melas et al. (27). The residue (glutenins) was extracted stepwise with 50% (v/v) aqueous 2-propanol containing TrisHCl (0.08 mol/L, pH 8) and dithiothreitol (1.0%) under nitrogen at 60 °C after removal of albumins, globulins, and gliadins with 60% (v/v) aqueous ethanol. After centrifugation, HMW subunits of glutenin were precipitated by the addition of acetone to a final concentration of 40% (v/v), whereas LMW subunits of glutenin remained in solution. All fractions were dialyzed against nitrogen-saturated acetic acid (0.01 mol/L) and freeze-dried. LMW subunits of glutenin were reoxidized with potassium bromate (KBrO3) and potassium iodate (KIO3), respectively, at different pH values (pH 2, 4, 6, and 8) according to the method of Antes and Wieser (28). Furthermore, stored LMW and HMW subunits of glutenin (stored for 2 years under ambient air and temperature conditions) as well as commercial gluten and commercial gliadin (Sigma, Deisenhofen, Germany) were analyzed. To prepare the samples for XANES measurements, 20 mg of freeze-dried subunits of glutenin, gluten and gliadin, respectively, was pressed to a thin homogeneous film. X-ray Absorption SpectroscopysExperimental. The XANES spectra were recorded at beamline BN3 using synchrotron radiation of the electron stretcher accelerator (ELSA) of the Institute of Physics, Bonn, Germany (29). The storage ring was operated at an energy of 2.3 GeV with electron currents between 70 and 20 mA. The synchrotron radiation was monochromatized by a modified Lemonnier-type doublecrystal monochromator (30) equipped with InSb (111) crystals. The monochromatic flux rate per second was some 109 photons (at 50 mA). The measurements were performed in transmission mode with ionization chambers (filled with 60 mbar of air), measuring the beam intensities in front of and behind the sample. For energy calibration of the spectra, the S K-edge XANES spectrum of zinc sulfate was used as a “secondary standard”. The maximum of the first resonance (so-called white line) was set to an energy of 2481.40 eV. According to the step width, this value is reproducible to (0.09 eV ((1 step). Spectra were scanned with step widths of 0.6 eV in the pre-edge region between 2450 and 2460 eV, 0.09 eV between 2460 and 2490, and 0.2 eV between 2490 and 2510 eV according to the spectral features of interest and with an integration time of 1000 ms per point. Further details of the experimental setup have been published previously (31). A linear background determined in the pre-edge region was subtracted from the raw data to correct for the absorption from higher shells and from supporting materials. Spectra were normalized at 2510 eV, where the variation of the absorption cross section is small. Reference Compounds. Glutathione (γ-L-glutamyl-L-cysteinylglycine; oxidized and reduced forms), methionine, dimethyl sulfoxide, cysteic acid, and zinc sulfate were used as reference compounds. These compounds were of reagent grade, purchased from Sigma, and used as received. Solids were ground to fine powder of ∼1 µm particle size and put homogeneously on a self-adhesive Kapton film available from CWC Klebetechnik (Frankenthal, Germany). Dimethyl sulfoxide was pipetted on a sulfur-free filter paper for measurements. The thickness of the samples was optimized in order to avoid possible thickness as well as pinhole effects. Quantitative Analysis of XANES Spectra. To analyze the XANES spectra quantitatively, the interactive fitting and plotting package MnFit 4.04/15 (available at http://zina06.physik.uni-bonn.de/∼brock/ mn_fit.html) was used. Mn-Fit 4.04/15 uses the minimization tool “MINUIT”, which is part of the CERNlib available at CERN-European Organization for Nuclear Research (http://wwwinfo.cern.ch/asdoc/ minuit/node2.html) to fit histograms or data. MINUIT provides tools

Sulfur Speciation in LMW Subunits of Glutenin

J. Agric. Food Chem., Vol. 51, No. 25, 2003

7433

Table 1. Results of Fitting the Sulfur K-Edge XANES Spectra of Different LMW and HMW Subunits of Glutenin, Gluten, and Gliadin

(cf. Figures 4, 6, and 7) to the Sum of Different Reference Spectra (cf. Figure 2)a percentage contribution of sulfur speciation C−S−H (GSHb)

C−S−S−C (GSSGb)

C−S−C (methionine)

C−SO−C (dimethyl sulfoxide)

C−SO3−C (cysteic acid)

SO42(zinc sulfate)

4 17 19 14 21 22 32 14 40 − − 12 17

39 53 60 43 44 44 55 49 7 5 4 65 71

7 − − 36 − − − 32 53 9 11 24 13

10 2 2 − 1 1 − − − 6 8 − −

39 27 18 5 33 33 13 4 − 79 76 − −

− − − − − − − −

LMWc (bromate, pH2) LMWc (bromate, pH 4) LMWc (bromate, pH 6) LMWc (bromate, pH 8) LMWc (iodate, pH 2) LMWc (iodate, pH 4) LMWc (iodate, pH 6) LMWc (iodate, pH 8) LMWc (reduced) HMWd (aged) LMWc (aged) gluten gliadin

− − − −

a Reference compounds for the different sulfur species are shown in parentheses. Error: e±10%; −, contribution