Addition/Correction pubs.acs.org/IECR
Correction to “Gas-Phase Surface Engineering of Polystyrene Beads Used to Challenge Automated Particles Inspection Systems” Vickie Labonté, Antoine Marion, Nick Virgilio, and Jason R. Tavares* Ind. Eng. Chem. Res. 2016, 55, 7362−7372, DOI: 10.1021/acs.iecr.6b01573 Pages 7363−7364: A calibration error on our radiometer caused us to misreport the irradiance values for the UVC lamps used in our original manuscript. The affected statements, which begin the subsection entitled “Surface Functionalization in the PICVD Reactor”, were published as follows: “The reaction chamber consists of two 45 × 2.5 cm quartz tubes connected end-to-end and illuminated by two 30 W UVC mercury lamps (Cole-Parmer VL-230-G) both emitting at 253.7 nm with an average irradiance of 0.38 ± 0.05 mW/cm2 at a distance of 2 cm. The irradiance was measured with an ILT 1700 Research Radiometer (International Light Technologies) coupled with a SED240 detector.” The corrected text should read as follows (where the corrected text is shown in boldface font): “The reaction chamber consists of two 45 × 2.5 cm quartz tubes connected end-to-end and illuminated by two 30 W UVC mercury lamps (Cole-Parmer VL-230-G) both emitting at 253.7 nm with an average irradiance of 0.010 ± 0.001 W/cm2 at a distance of 3.5 cm. The irradiance was measured with an ILT 1700 Research Radiometer (International Light Technologies) coupled with a SED240 detector.”
Published: October 7, 2016 © 2016 American Chemical Society
11035
DOI: 10.1021/acs.iecr.6b03762 Ind. Eng. Chem. Res. 2016, 55, 11035−11035
