Study on a Novel Cross-Linked Polymer Gel Strengthened with Silica

Jul 30, 2017 - China National Offshore Oil Corporation Research Institute, Beijing 100028, People's Republic of China. § School of Energy Resources, ...
0 downloads 5 Views 3MB Size
Subscriber access provided by University of Rochester | River Campus & Miner Libraries

Article

Study on a Novel Crosslinked Polymer Gel Strengthened with Silica Nanoparticles Yifei Liu, Caili Dai, Kai Wang, Chenwei Zou, Mingwei Gao, Yanchao Fang, Mingwei Zhao, Yining Wu, and Qing You Energy Fuels, Just Accepted Manuscript • DOI: 10.1021/acs.energyfuels.7b01432 • Publication Date (Web): 30 Jul 2017 Downloaded from http://pubs.acs.org on August 10, 2017

Just Accepted “Just Accepted” manuscripts have been peer-reviewed and accepted for publication. They are posted online prior to technical editing, formatting for publication and author proofing. The American Chemical Society provides “Just Accepted” as a free service to the research community to expedite the dissemination of scientific material as soon as possible after acceptance. “Just Accepted” manuscripts appear in full in PDF format accompanied by an HTML abstract. “Just Accepted” manuscripts have been fully peer reviewed, but should not be considered the official version of record. They are accessible to all readers and citable by the Digital Object Identifier (DOI®). “Just Accepted” is an optional service offered to authors. Therefore, the “Just Accepted” Web site may not include all articles that will be published in the journal. After a manuscript is technically edited and formatted, it will be removed from the “Just Accepted” Web site and published as an ASAP article. Note that technical editing may introduce minor changes to the manuscript text and/or graphics which could affect content, and all legal disclaimers and ethical guidelines that apply to the journal pertain. ACS cannot be held responsible for errors or consequences arising from the use of information contained in these “Just Accepted” manuscripts.

Energy & Fuels is published by the American Chemical Society. 1155 Sixteenth Street N.W., Washington, DC 20036 Published by American Chemical Society. Copyright © American Chemical Society. However, no copyright claim is made to original U.S. Government works, or works produced by employees of any Commonwealth realm Crown government in the course of their duties.

Page 1 of 32

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Energy & Fuels

1

Study on a Novel Crosslinked Polymer Gel Strengthened with Silica

2

Nanoparticles

3

Yifei Liu1, Caili Dai1∗, Kai Wang2, Chenwei Zou1, Mingwei Gao1, Yanchao Fang1,Mingwei Zhao1,

4

Yining Wu1, Qing You3∗

5

1 School of Petroleum Engineering, State Key Laboratory of Heavy Oil, China University of Petroleum (East

6

China), Qingdao, Shandong, 266580, People’s Republic of China, 2 China National Offshore Oil Corporation

7

Research Institute, Beijing, 100028, People’s Republic of China, 3 School of Energy Resources, China University of

8

Geosciences, Beijing, 100083, People’s Republic of China.



Caili Dai

Email: [email protected] Tel: +86-532-86981183



Qing You

Fax: +86-532-86981161

Email: [email protected] Tel: +86-010-82322754 1

ACS Paragon Plus Environment

Energy & Fuels

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

1

Page 2 of 32

Abstract

2

This paper studied the strengthening effects of silica nanoparticles on the polyacrylamide

3

(PAM)/hydroquinone (HQ)-hexamethylenetetramine (HMTA) composite gel. Pure PAM/HQ-HMTA gel and

4

PAM/HQ-HMTA gels containing silica nanoparticles up to 0.3 wt% were prepared at 110 °C. Influences of

5

silica nanoparticles on gelation performances were systematically evaluated. By addition of silica

6

nanoparticles, the gelation time became shorter and the gel strength was improved observably. Rheological

7

measurements showed that silica nanoparticles enhanced both elasticity and viscosity of the gel significantly.

8

Thermal stability of the gel was studied by differential scanning calorimetry (DSC) measurements. The

9

maximum tolerated temperature of the gel was improved from 137.8 °C to 155.5 °C by addition of silica

10

nanoparticles with a concentration of 0.3 wt%. Furthermore, to study the strengthening mechanisms of silica

11

nanoparticles to the gel, the microstructure and existing state of water within the gel were investigated by

12

environmental scanning electron microscopy (ESEM) measurement and DSC measurement. Micrographs of

13

the gel showed that massive aggregations and arrangements of silica nanoparticles existed in uniformly

14

distributed three-dimensional network structures of the gel, which greatly improved the structural strength of

15

the gel. Moreover, mass fraction of bound water within the gel increased from 22.5% to 39.9% by addition

16

of silica nanoparticles with a concentration of 0.3 wt%. The hydrogen bonds and electrostatic attractions

17

between silica nanoparticles and water molecules/hydronium ions make higher bound water ratio, which

18

contributes to better water holding capacity and thermal stability of the gel.

19

2 ACS Paragon Plus Environment

Page 3 of 32

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

1

Energy & Fuels

1. Introduction

2

Global demand for crude oil as the important energy resource and chemical raw material is growing

3

constantly with the increase of word economy.1 However, almost all reservoirs are heterogeneous, which

4

leads to early water breakthrough into production wells along high permeability zones. The water

5

breakthrough results in low sweep efficiency, high water cut, low oil recovery and high remaining oil

6

saturation, which makes uneconomic water-flooding, high-cost sewage treatment and severe environment

7

contamination.1-7 As reported, there is approximately 70% remaining oil left in the unswept zones of

8

heterogeneous reservoirs.8 Thus, controlling water cut and increasing oil production is always the real

9

challenge for field operators.8-10 And increasing sweep efficiency is the key to increasing oil production and

10

reducing water production.1

11

Until now, various crosslinked polymer gels are still the most commonly used techniques to improve

12

sweep efficiency for enhanced oil production and reducing excessive water production.11, 12 In general, the

13

crosslinkers used to prepare crosslinked polymer gels can be either metallic or organic.13 Metallic

14

crosslinkers crosslink with polymers by ionic bonds, while organic crosslinkers crosslink with the polymers

15

by covalent bonds. The metallic crosslinkers, such as Cr3+, Zr4+, and Al3+, are known to be toxic and

16

environmentally unacceptable.14 Moreover, metallically cross-linked gels typically have poor thermal

17

stability and short gelation time at temperatures higher than 60~70 °C, which are not suitable for high

18

temperature reservoirs.15,

19

polymer gels are with better thermal stability and longer gelation time, even at elevated temperatures.15 This

20

owes to the covalent bonds formed by the polymers and organic crosslikers, which are with higher bond

21

energy than ionic bonds.

16

Compared with the metallically cross-linked gels, organically cross-linked

22

Several organically crosslinked polymer gels have been reported in the literatures, among which the

23

phenol-formaldehyde gel and polyethylene imine (PEI) gel draw more attention.17-21 The PEI crosslinker is

24

nontoxic and environmentally friendly, however, the high price limits its application.22 In contrast, the 3 ACS Paragon Plus Environment

Energy & Fuels

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Page 4 of 32

1

crosslinker composed of phenol-formaldehyde is cheap, but the main problem is that the phenol and

2

formaldehyde are toxic, especially the carcinogenic character of formaldehyde.15 To overcome the above

3

problem, researchers find the substitutes with lower toxicity for phenol and formaldehyde, such as

4

hydroquinone (HQ) and hexamethylenetetramine (HMTA). Former studies have shown that the HQ-HMTA

5

crosslinked polymer gels are with longer gelation time and better thermal stability than the other organically

6

crosslinked gels, which have been successfully applied in four high temperature oilfields, among which the

7

highest reservoir temperature is about 121 °C, for water shutoff treatment.13, 23

8

In addition, the gels prepared with solid particles have drawn great attention in recent years due to their

9

excellent performances compared with the gels unreinforced.24-28 Zhou et al.29, 30 developed a clay-gel for

10

water shut-off in reservoirs with high permeability channels. The prepared gel showed high gel strength,

11

good thermal stability and significant plugging effect. However, the gel system is only applicable for

12

blocking fractures and wormholes, moreover, the salinity of the formation water has to be low (