Effect of Organic Matter and Thermal Maturity on Methane Adsorption

Sep 28, 2017 - This set of data represents meaningful information for indirect estimations of the gas in place during the future recovery strategies. ...
0 downloads 11 Views 3MB Size
Article pubs.acs.org/EF

Cite This: Energy Fuels XXXX, XXX, XXX-XXX

Effect of Organic Matter and Thermal Maturity on Methane Adsorption Capacity on Shales from the Middle Magdalena Valley Basin in Colombia Olga Patricia Ortiz Cancino,*,† Deneb Peredo Mancilla,‡ Manuel Pozo,§ Edgar Pérez,∥ and David Bessieres‡ †

Universidad Industrial de Santander, Bucaramanga, Santander 680002, Colombia Université de Pau et des Pays de l’Adour, CNRS, UMR 5150, Laboratoire des Fluides Complexes et leurs Réservoirs, TOTAL, 64013 Pau, France § Department of Geology and Geochemistry, Universidad Autónoma de Madrid (UAM), Cantoblanco, 28049 Madrid, Spain ∥ Instituto Colombiano del Petróleo (ICP), Piedecuesta, Santander 681018, Colombia ‡

ABSTRACT: High-pressure methane adsorption isotherms were measured on five shale core samples obtained during exploratory drilling from three boreholes located in the Colombian Middle Magdalena Valley Basin. The experiments were carried out at 50 and 75 °C and for pressures ranging up to 3.5 MPa under dry conditions through the use of a homemade manometric setup. The effect of the total organic carbon (TOC) content, thermal maturity, clay content, and specific surface area (SSA) on methane adsorption capacity has been discussed. The excess adsorption data were fitted to a three-parameter (nL, pL, and ρads) Langmuir model with the value of the adsorbed phase density, ρads, maintained fixed at 421 kg/m3, which corresponds to liquid-phase density of methane at a normal boiling point. An excellent fit to the experimental data was achieved. The results show that the temperature has a negative effect on the adsorption capacity, while TOC has a positive effect, even if no linear regression was found between TOC and methane adsorption capacity. No correlation was observed between the clay content and the TOC-normalized adsorption capacity to methane, which indicates that clay minerals do not significantly contribute to methane adsorption in the case of our samples. In addition, there is not a general trend between TOC normalized and thermal maturity. Among the factors investigated in the present study, TOC has the major contribution to the adsorption uptake. A similar contribution is found for the SSA, which is consistent, considering the positive correlation between TOC and SSA. This set of data represents meaningful information for indirect estimations of the gas in place during the future recovery strategies. This study furthers the ongoing projects on the understanding of the adsorption effect on shale gas production and assessment.

1. INTRODUCTION In 2016, according to the BP Statistical Review of World Energy,1 the natural gas production of Colombia was almost equal to its consumption and the reserves/production (R/P) ratio was close to 12. At the present time, almost all of the natural gas production of country comes from conventional reserves, which could be empty by the year 2028; meanwhile, unconventional technically recoverable gas reserves are estimated to be 12 times greater than conventional reserves.2 Shale gas has become an increasingly important source of natural gas supply. It is of general acceptance that natural gas can be stored in shales in three different ways: as free gas, adsorbed gas, and dissolved gas,3−8 with adsorbed gas being the main contribution (up to 85%).3,9−12 Therefore, the quantity of adsorbed gas represents one of the most important parameters in gas shale reserves and production estimations.13 In this sense, many laboratory experiments have been carried out on methane adsorption in shale gas from different worldwide basins, with the objective to provide a better understanding of this phemomenon.7,14−23 In addition to adsorption measurements, some works had obtained at the same time the stored free-gas amount, with the confining-stress effect having been taken into account.24−26 © XXXX American Chemical Society

Adsorption is a complex process, which depends upon the rock matrix and fluid properties as well as reservoir conditions (e.g., temperature and pressure). The main parameters affecting adsorption capacity are the total organic carbon (TOC) content, mineralogy, water content, temperature, and pressure. Most of the studies affirm that organic matter, TOC, is the main factor that controls adsorption uptake in shales.8,18−23 It has also been reported that the type of kerogen as well as its maturity can influence the adsorption ability in such a way that the methane adsorption capacity of kerogen decreases in the sense of type III > type II > type I,7,18 while a higher maturity means a higher adsorption capacity.8,20,27 Others studies reported that sorption capacity will first increase and then decrease with maturity.28,29 The roles of shale mineral composition and pore structure have been largely studied.8,28 In addition to organic matter, clay mineral may provide a contribution upon adsorption capacity.4,7,8,23,27,30−32 Montmorillonite and illite/smectite present a higher adsorption capacity than kaolinite, chlorite, and illite.30 At a nanometric scale, it is difficult to correlate the adsorption gas capacity Received: June 30, 2017 Revised: September 27, 2017 Published: September 28, 2017 A

DOI: 10.1021/acs.energyfuels.7b01849 Energy Fuels XXXX, XXX, XXX−XXX

Article

Energy & Fuels

Figure 1. Location of the Middle Magdalena Valley (in yellow) and sample site (black circle) [modified with permission from ref 40. Copyright 2007 Agencia Nacional de Hidrocarburos (ANH)].

Figure 2. Schematic diagram of the HP/high-temperature (HT) manometric setup.

directly with the total organic content as a result of the pore size distribution and heterogeneity of the surface;8 therefore, some authors suggest that the adsorbed gas volume evaluation should also be related to the surface area.12,33−35 The adsorption in clay-rich shales is due to their high internal area. Therefore, the specific surface area (SSA) plays a significant role in gas adsorption36 as a result of the microporosity associated with organic matter. Zhang et al.37 report that shales with a higher content of clay minerals and a similar TOC content have a larger SSA. This is due to the porosity hosted in the clay minerals. Pressure increases the adsorption capacity to some extent when it rises isothermally.38 In contrast, the water content and temperature have a negative influence. Water may occupy the adsorption sites, hence reducing the amount of adsorbed gas.20,39

A reduction in gas adsorption up to 40% has been found when comparing moisture samples to dry samples.7,8 The temperature is also one of the factors influencing the state of shale gas. With gas adsorption being an exothermic process, the adsorption capacity of shale decreases with an increasing temperature.6,23 The combined effect of the pressure and temperature can be used during the production stage because it represents gas desorption behavior.11 Although the above-mentioned parameters are the most studied, some works have been performed focused to dynamically changing pore volume adjustments as a result of the adsorption layer taking up space and overburden effects on core shale samples.24−26 This review highlights that gas storage in shale is a complex multi-parameter process. An understanding and quantification B

DOI: 10.1021/acs.energyfuels.7b01849 Energy Fuels XXXX, XXX, XXX−XXX

Article

Energy & Fuels Table 1. Depth and Mineralogical Analysis of the Samples sample

depth (m)

illite (%, w/w)

kaolinite (%, w/w)

quartz (%, w/w)

calcite (%, w/w)

pyrite (%, w/w)

gypsum (%, w/w)

apatite (%, w/w)

S1A S1B S2A S2B S3

2835 2850 2934 3004 4430

15 11 9 13 7

45 19 21 15 22

27 54 31 11 32

3 10 33 50 28

10 6 4 9 8

id id id id id

0 0