Electrochemically Controlled Growth and Positioning of Suspended

Nov 29, 2007 - This approach could benefit lab-on-a-chip technologies for the rational ... field6-10 and pH,1,11,12 can be used in concert to form sus...
0 downloads 0 Views 89KB Size
2970

Langmuir 2008, 24, 2970-2972

Electrochemically Controlled Growth and Positioning of Suspended Collagen Membranes Holly R. Baker,† Erika F. Merschrod S,*,‡ and Kristin M. Poduska*,† Department of Physics and Physical Oceanography and Department of Chemistry, Memorial UniVersity of Newfoundland, St. John’s NL A1B 3X7, Canada ReceiVed NoVember 29, 2007. In Final Form: February 1, 2008 Two independently recognized in vitro polymer aggregation variables, electric field and pH, can be used in concert to produce suspended membranes from solutions of type I collagen monomers, without need of a supporting substrate. A collagen network film can form at the alkaline-acidic pH interface created during the normal course of water electrolysis with parallel plate electrodes, and the anchoring location can be controlled by adjusting the bulk electrolyte pH. Electrosynthesized films remain intact upon drying and rehydration and function as ion-separation membranes even in submillimeter channels. This approach could benefit lab-on-a-chip technologies for the rational placement of membranes in microfluidic devices.

Introduction protein,1

Films of collagen, the most abundant mammalian are sought for prosthetic coatings, as support matrices for cell growth, and for permeable membranes.2 However, many in vitro collagen films are substrate-supported,2-5 which limits their use as membranes. Our results demonstrate that two independently recognized in vitro polymer aggregation variables, electric field6-10 and pH,1,11,12 can be used in concert to form suspended collagen network films, without the presence of a supporting substrate. This approach could benefit lab-on-a-chip technologies13 for the rational placement of ion-separation membranes in microfluidic devices. Collagen’s function in the body is intimately related to its structural transformations through aggregation. Conveniently, the hierarchical collagen structures observed from in vivo14,15 collagen aggregation can be replicated in vitro,11,14 without need of biological assistance from enzymes or growth factors. Collagen monomers can form oligomers that grow linearly and laterally and cross link to create fibrils.15 Alternate aggregation pathways * Corresponding authors. E-mail: [email protected], [email protected]. † Department of Physics and Physical Oceanography. ‡ Department of Chemistry. (1) Nimni, N. E. Collagen; CRC Press: Boca Raton, FL, 1988; Vol. 1. (2) (a) Reyes, C. D.; Petrie, T. A.; Burns, K. L.; Schwartz, Z.; Garcı´a, A. J. Biomaterials 2007, 28, 3228-3235. (b) Gopinath, D.; Rafiuddin Ahmed, M.; Gomathi, K.; Chitra, K.; Sehgal, P. K.; Jayakumar, R. Biomaterials 2004, 25, 1911-1917. (3) Nath, N.; Hyun, J.; Ma, H.; Chilkoti, A. Surf. Sci. 2004, 570, 98-110. (4) Wisniewski, M.; Sionkowska, A.; Kaczmarek, H.; Lazare, S.; Tokarev, V.; Belin, C. J. Photochem. Photobiol., A 2007, 188, 192-199. (5) Elliott, J. T.; Woodward, J. T.; Umarji, A.; Mei, Y.; Tona, A. Biomaterials 2007, 28, 576-585. (6) Worley, C. G.; Linton, R. W.; Samulski, E. T. Langmuir 1995, 11, 38053810. (7) Porschke, D. Ann. ReV. Phys. Chem. 1985, 36, 159-178. (8) Chao, C.-Y.; Li, X.; Ober, C. K.; Osuji, C.; Thomas, E. L. AdV. Funct. Mater. 2004, 14, 364-370. (9) Freudenberg, U.; Behrens, S. H.; Welzel, P. B.; Mu¨ller, M.; Grimmer, M.; Salchert, K.; Taeger, T.; Schmidt, K.; Pompe, W.; Werner, C. Biophys. J. 2007, 92, 2108-2119. (10) Huelin, S. D.; Baker, H. R.; Poduska, K. M.; Merschrod S., E. F. Macromolecules 2007, 40, 8440-8444. (11) Goh, M. C.; Paige, M. F.; Gale, M. A.; Yadegari, I.; Edirisinghe, M.; Strzelczyk, J. Physica A 1997, 239, 95-102. (12) Ko¨ster, S.; Leach, J. B.; Struth, B.; Pfohl, T.; Wong, J. Y. Langmuir 2007, 23, 357-359. (13) Atencia, J.; Beebe, D. J. Nature 2005, 437, 648-655. (14) Kadler, K. E.; Holmes, D. F.; Trotter, J. A.; Chapman, J. A. Biochem. J. 1996, 316, 1-11. (15) Ottani, V.; Martini, D.; Franchi, M.; Ruggeri, A.; Raspanti, M. Micron 2002, 33, 587-596.

produce different aggregate or fibril morphologies.1,15,16 Controlled collagen aggregation requires the management of electrostatics, sterics, and hydrophobicity, all of which can be affected by pH.1,14,15 Adding an electric field places further importance on electrostatics and charge. Collagen’s surface charge is pH-dependent as a result of amino acid protonation at acidic pH values and deprotonation at alkaline pH values.17 Collagen, when net charged, migrates in an electric field like any charged polymer,7,8 but beyond that, collagen’s behavior in an electric field has not been widely investigated,10,17 despite the increasing use of electrochemical methods to create biopolymer and biocomposite coatings.2,18 Collagen is electrochemically inactive over a wide range of applied potentials.19 However, a sufficiently large voltage applied to its aqueous supporting electrolyte causes alkaline conditions near the cathode as a result of the hydrogen evolution reaction (HER, with E0 ) -0.83 vs normal hydrogen electrode (NHE)) and acidic pH near the anode (oxygen evolution reaction, with E0 ) +1.71 vs NHE), which can influence collagen migration and aggregation. The reduction of ambient dissolved oxygen also contributes to the pH change near the cathode. By exposing collagen monomers to the simultaneous pH gradient and electric field produced in an electrochemical cell, we have developed a method to control the spatial aggregation of collagen in the electrolyte, without need for a supporting substrate. Experimental Section Electrolytes, prepared using ultrapure water (Barnstead, 18.2 MΩ), contained type I collagen monomers (final concentration 0.07-0.30 mg/mL from 3 mg/mL Vitrogen stock solution, Inamed Biomaterials) and sufficient NaOH and HCl solutions (EMD chemicals, ACS reagent grade) to adjust the pH to the desired value (4-11). Stainless steel sheet electrodes provided an electric field of 5-10 V over 1.0-2.5 cm, yielding a current density of -0.7 to -1.2 mA/cm2. These voltages are large relative to the potentials required for the HER, oxygen evolution, and oxygen reduction reactions. Macroscopic (16) Paige, M. F.; Goh, M. C. Micron 2001, 32, 355-361. (17) Tanaka, S.; Hata, R. I.; Nagai, Y. Collagen Rel. Res. 1981, 1, 237-246. (18) (a) Cosman, N. P.; Roscoe, S. G. Langmuir 2004, 20, 1711-1720. (b) Burgess, I.; Li, M.; Horswell, S. L.; Szymanski, G.; Lipkowski, J.; Satija, S.; Majewski, J. Colloids Surf., B 2005, 40, 117-122. (c) Cheng, X.; Filiaggi, M.; Roscoe, S. G. Biomaterials 2004, 25, 5395-5403. (d) Fan., Y.; Duan, K.; Wang, R. Biomaterials 2005, 26, 1623-1632. (19) Li, M.; He, P.; Zhang, Y.; Hu, N. Biochim. Biophys. Acta 2005, 1749, 43-51.

10.1021/la703743m CCC: $40.75 © 2008 American Chemical Society Published on Web 03/07/2008

Letters

Langmuir, Vol. 24, No. 7, 2008 2971

Figure 1. Electrosynthesized collagen network films can be macroscopic and removable (a) or synthesized in smaller channels (b). The macroscopic film in part a is shown during its later stages of growth, viewed edge-on with in situ polarized light microscopy. The edge-on view of the submillimeter film in part b depicts the early stages of formation relative to the acidic and alkaline regions of the surrounding electrolyte. Air-dried collagen films, viewed with crossed polarizers, are sheetlike (c); higher magnifications (d) highlight their complex network structure. films were formed in a glass electrochemical cell designed and built in-house (2.5 cm × 2.5 cm × 1 cm, 3.5 mL volume), whereas smaller films were prepared in 1-cm-long glass (1.1 mm ID) or polyethylene (1.57 or 0.86 mm ID) capillaries. We note that, whereas it is possible for peroxide to form at the cathode during the hydrogen and oxygen reduction processes, we do not observe any film degradation due to the presence of such strong oxidants on the time scales of our experiments (up to several hours). Optical microscopy investigations employed a Leica DM2500 with polarized light capability. Atomic force microscopy studies with an Asylum Research MFP-3D used silicon cantilevers (Au back coating, force constant ∼0.3 N/m, Mikromasch). Raman scattering spectroscopy data were obtained with a Jobin Yvon Horiba LabRAM in the confocal configuration (532 nm excitation). Within minutes of exposing a pH-adjusted electrolyte of collagen monomers (0.3 mg/mL) to an electric field (3-20 V/cm), a collagen film, visible to the eye, forms in the electrolyte, parallel to the anode and cathode and with its edges anchored to the container walls, whether glass or polyethylene. Videos and representative current versus time data taken during the film-formation process are available as Supporting Information.

Results and Discussion Our electrosynthesis method for forming collagen films controls three essential stages of collagen aggregation: localization, organization, and association. The coexistence of the electric field and pH gradient enables a spatially localized region of high collagen concentration through a serendipitous combination of pH-dependent surface charge and the resulting electromobility it induces. When the electric field is first applied, collagen migrates away from the anode10 to build up a critical mass of collagen near the middle of the cell. As the collagen migrates closer to the pH region that matches its isoelectric point, it approaches net neutral charge and is less affected by the electric field. These changes in surface charge distribution impact charge association and polymer alignment.6,10 Figure 1a,b shows electrosynthesized suspended collagen films, one with centimeter-scale dimensions (2.5 cm2) prepared in an open cell and another with submillimeter dimensions (0.01 cm2) prepared in a glass capillary. Macroscopic collagen films can be removed while wet, air dried, and rehydrated to recover their pliability. The films are brittle when dry but flexible when partially wetted. They are robust enough to be handled with tweezers. Optical micrographs of a dried, partially folded film portray the sheetlike nature of the film (Figure 1c), and higher magnifications (Figure 1d) highlight the complex microstructure of the collagen

Figure 2. Raman spectra indicate heterogeneous aggregation in the air-dried electrosynthesized collagen film (two regions, A and B) when compared with spectra for air-dried monomeric and fibrillar collagen. The C-N stretch (∼1100 cm-1, strongest intensity for fibrillar collagen), amide I (1630-1670 cm-1), and amide III (12401270 cm-1) regions are most sensitive to conformational changes.

sheets. Atomic force microscopy (AFM) studies show that air drying reduces the film thickness from ∼100 µm to 0.6 ( 0.2 µm. AFM images presented in Supporting Information show the continuation of the meshlike structure on the micrometer length scale. Raman scattering spectroscopy can indicate the degree and type of monomer association in polymeric films.4,20 Figure 2 compares the Raman spectra for our collagen films with those for precursor monomers and for fibrils prepared by a standard dialysis method.14 On the basis of Raman data from the amide I (1630-1670 cm-1), amide III (1240-1270 cm-1), and C-N stretch (1095 cm-1) regions,4 along with supporting AFM studies shown in the Supporting Information, we conclude that our electrosynthesized collagen films are heterogeneous, containing a relatively high amount of monomeric collagen. The aggregational heterogeneity evident in the Raman data suggests a time-dependent conversion from nonspecific monomer aggregates to collagen fibrils during electrosynthesis. Early in the film formation, it is possible to dissolve the film partially or wholly and reform it at a different location in the electrochemical cell simply by reversing the polarity of the applied electric field. However, films formed for longer times show incomplete or minimal dissolution upon field reversal, suggesting that more robust and massive fibrils21 exist after prolonged exposure to electric field and pH gradients. Despite the mixture of monomeric and fibrillar collagen, film formation and function are quite reliable when three key experimental parameters are controlled First, there exists a collagen concentration threshold below which no filmlike aggregation occurs, which is dependent on the volume of electrolyte relative to the surface area of the desired collagen film. Surface area to volume ratios near 1 cm2/1 mL, consistent with the conditions used to produce the films shown in Figure 1, required collagen concentrations of 0.10-0.30 mg/mL. Second, a sufficiently large electric field is essential for spatially controlled aggregation. Earlier studies that employed pH gradients in the absence of an electric field12 report collagen aggregation but no evidence of film formation in the electrolyte. Other conditions10 demonstrate the electromigration of positively charged collagen away from an anode for smaller electric fields (