Emissions of Nanoparticles and Gaseous Material from 3D Printer

Sep 24, 2015 - The GC-MS was programmed with a 1.60 min solvent delay, and an ...... https://www.osha.gov/dts/sltc/methods/organic/org104/org104.html ...
0 downloads 0 Views 2MB Size
Article pubs.acs.org/est

Emissions of Nanoparticles and Gaseous Material from 3D Printer Operation Yuna Kim,† Chungsik Yoon,*,†,‡ Seunghon Ham,†,‡ Jihoon Park,† Songha Kim,† Ohhun Kwon,† and Perng-Jy Tsai§ †

Department of Environmental Health, School of Public Health, Seoul National University, 1, Gwanak-ro, Gwanak-gu, Seoul 151-742, Republic of Korea ‡ Institute of Health and Environment, School of Public Health, Seoul National University, 1, Gwanak-ro, Gwanak-gu, Seoul 151-742, Republic of Korea § Department of Environmental and Occupational Health, Medical College, National Cheng Kung University, 138, Sheng-Li Rd., Tainan 70428, Taiwan S Supporting Information *

ABSTRACT: This study evaluated the emissions characteristics of hazardous material during fused deposition modeling type 3D printing. Particulate and gaseous materials were measured before, during, and after 3D printing in an exposure chamber. One ABS and two PLA (PLA1 and PLA2) cartridges were tested three times. For online monitoring, a scanning mobility particle sizer, light scattering instrument, and total volatile organic compound (TVOC) monitor were employed and a polycarbonate filter and various adsorbent tubes were used for offline sampling. The particle concentration of 3D printing using ABS material was 33−38 times higher than when PLA materials were used. Most particles were nanosize (