Gas-Phase Detection of Fluorotelomer Alcohols and Other

Apr 11, 2019 - Per- and polyfluoroalkyl substances (PFAS) are incorporated into an ever-increasing number of modern products and inevitably enter the ...
0 downloads 0 Views 292KB Size
Subscriber access provided by SAM HOUSTON STATE UNIV

Environmental Measurements Methods

Gas-Phase Detection of Fluorotelomer Alcohols and Other Oxygenated PFAS by Chemical Ionization Mass Spectrometry Theran P. Riedel, Johnsie Lang, Mark J. Strynar, Andrew B. Lindstrom, and John H. Offenberg Environ. Sci. Technol. Lett., Just Accepted Manuscript • DOI: 10.1021/acs.estlett.9b00196 • Publication Date (Web): 11 Apr 2019 Downloaded from http://pubs.acs.org on April 14, 2019

Just Accepted “Just Accepted” manuscripts have been peer-reviewed and accepted for publication. They are posted online prior to technical editing, formatting for publication and author proofing. The American Chemical Society provides “Just Accepted” as a service to the research community to expedite the dissemination of scientific material as soon as possible after acceptance. “Just Accepted” manuscripts appear in full in PDF format accompanied by an HTML abstract. “Just Accepted” manuscripts have been fully peer reviewed, but should not be considered the official version of record. They are citable by the Digital Object Identifier (DOI®). “Just Accepted” is an optional service offered to authors. Therefore, the “Just Accepted” Web site may not include all articles that will be published in the journal. After a manuscript is technically edited and formatted, it will be removed from the “Just Accepted” Web site and published as an ASAP article. Note that technical editing may introduce minor changes to the manuscript text and/or graphics which could affect content, and all legal disclaimers and ethical guidelines that apply to the journal pertain. ACS cannot be held responsible for errors or consequences arising from the use of information contained in these “Just Accepted” manuscripts.

is published by the American Chemical Society. 1155 Sixteenth Street N.W., Washington, DC 20036 Published by American Chemical Society. Copyright © American Chemical Society. However, no copyright claim is made to original U.S. Government works, or works produced by employees of any Commonwealth realm Crown government in the course of their duties.

Page 1 of 18

Environmental Science & Technology Letters

1

Gas-Phase Detection of Fluorotelomer Alcohols and Other Oxygenated PFAS by Chemical

2

Ionization Mass Spectrometry

3 4

Theran P. Riedel1*, Johnsie R. Lang2, Mark J. Strynar1, Andrew B. Lindstrom1, John H.

5

Offenberg1

6 7

1National

8

Research Triangle Park, North Carolina, 27711, United States

9

2Oak

Exposure Research Laboratory, United States Environmental Protection Agency,

Ridge Institute for Science and Education, National Health and Environmental Effects

10

Research Laboratory, United States Environmental Protection Agency, Research Triangle Park,

11

North Carolina, 27711, United States

12 13 14

*Corresponding Author

15

Email: [email protected]

16

Phone: 919-541-0877

ACS Paragon Plus Environment

1

Environmental Science & Technology Letters

Page 2 of 18

17

ABSTRACT

18

Per- and polyfluoroalkyl substances (PFAS) are incorporated into an ever-increasing number of

19

modern products and inevitably enter the environment and ultimately human bodies. Herein we

20

show that chemical ionization mass spectrometry with iodide reagent ion chemistry is a useful

21

technique for the detection of fluorotelomer alcohols (FTOHs) and other oxygenated PFAS,

22

including per- and polyfluoro carboxylic acids such as hexafluoropropylene oxide dimer acid. This

23

technique offers direct, high time resolution measurement capability with parts per trillion by

24

volume (ng m-3) gas-phase detection limits. Measurements were made by direct volatilization of

25

samples without prior processing, allowing for fast measurements and reduced sample treatment

26

compared to established PFAS methods. We demonstrate the utility of this technique by sampling

27

volatile and semivolatile PFAS from fluoro-additives and fluoro-products to quantify levels of

28

FTOHs and identify additional fluorinated compounds for which standards were unavailable.

29 30

INTRODUCTION

31

Per- and polyfluoroalkyl substances (PFAS) are used in a wide variety of industrial

32

applications including textile, materials, and chemical manufacturing due to beneficial mechanical

33

properties and relative inertness they can help lend to consumer and industrial products.1 Upon

34

release into the environment, these compounds are subject to slow or negligible environmental

35

degradation and are thus considered an emerging class of pollutants capable of persistent global

36

buildup and increasing human exposure.2-3

37

PFAS are believed to number in the thousands,4 without considering the likely complex

38

array of related environmental degradates. The rate with which these chemicals are produced and

39

released to environments often vastly outpaces the time required for the development of traditional

ACS Paragon Plus Environment

2

Page 3 of 18

Environmental Science & Technology Letters

40

measurement approaches that typically focus on a small subset of chemicals and occurs over

41

multiple years. As a consequence, human populations incur exposure and risk potentially for years

42

before the presence of contamination is recognized. Advances in high-resolution mass

43

spectrometry and data analytics provides a means of broadening the window of PFAS

44

identification to evaluate current occurrence rather than the multiyear lag of traditional methods.5

45

Fluorotelomer alcohols (FTOHs), perfluorinated carboxylic acids (PFCAs), and perfluoro

46

ether carboxylic acids (PFECAs) are three environmentally relevant and related classes of PFAS.

47

In this study we focus on four representative FTOHs, two PFCAs, and one PFECA: 4:2, 6:2, 8:2,

48

and 10:2 FTOH; perfluorooctanoic acid (PFOA); perfluorobutanoic acid (PFBA); and

49

hexafluoropropylene oxide dimer acid (HFPO-DA). FTOHs have been shown to be the dominant

50

PFAS measured in landfill gas, but measurements are limited to the fraction that can be collected

51

on impregnated foam disks.6 FTOHs can degrade to form certain PFCAs, which are extremely

52

stable compounds, and have been implicated to play a major role in the global dissemination of

53

PFCAs.7-9 PFOA has been linked to adverse health effects.10-11 It is often referred to as a “legacy”

54

PFAS since it has largely been phased out of industrial use over the past decade in the United

55

States and Europe but still remains environmentally relevant due to persistent levels in ground and

56

surface waters and landfills. HFPO-DA (perfluoro-2-propoxypropanoic acid) is often referred to

57

under the product name “GenX” and has received attention in states such as North Carolina where

58

PFAS manufacturing processes take place.12

59

Considering the long-chain fluorinated “tails” present on most PFAS, these compounds

60

have a considerably larger vapor pressure than equivalent hydrocarbon-based ones. For example,

61

dodecan-1-ol (C12H26O) has an equilibrium vapor pressure almost five hundred times less than that

ACS Paragon Plus Environment

3

Environmental Science & Technology Letters

Page 4 of 18

62

of 10:2 FTOH (C12F21H5O), an analogous FTOH.13-14 Thus, a significant fraction of PFAS can

63

reasonably be expected to be present in the gas phase, which is therefore a likely exposure pathway.

64

In comparison to condensed-phase measurements of PFAS, gas-phase assessments are rare,

65

largely due to the lack of established methods for reliable sample collection and quantification, but

66

such measurements are needed considering recent increases in awareness that gas-phase releases

67

may contribute significantly to overall PFAS from landfills and industrial sources. For example,

68

attempts to constrain HFPO-DA in industrial stack emissions at one facility resulted in vastly

69

different estimates of annual emissions: early estimates of 66.6 lb year-1 were adjusted to 2,758 lb

70

year-1, a 40-fold difference, when alternative methods were used.15

71

Previous publications regarding gas-phase PFAS field sampling techniques have largely

72

been limited to offline analyses of liquid-phase extracts (i.e. capture of PFAS from ambient air on

73

sorbent impregnated disks, followed by extraction and concentration for detection by gas

74

chromatography-mass spectrometry (GC-MS) and/or liquid chromatography-mass spectrometry

75

(LC-MS)).6, 16 Given the collection times, these approaches are rarely able to capture valuable

76

temporal information such as diurnal variations or emission plume intercepts which inevitably are

77

averaged and/or diluted over the entire collection period. Clearly, a real-time continuous

78

measurement technique for the detection of these compounds would be valuable.

79

In addition to field sampling, there is a need to accurately and directly quantify PFAS in

80

products like aqueous firefighting foams, industrial dispersions, and cleaners in order to better

81

constrain the contributions of such materials to the environmental PFAS burden from product

82

manufacturing and landfills. Previous publications that reported PFAS content of products used

83

extraction and cleanup steps where volatile or semivolatile PFAS could potentially be lost. For

ACS Paragon Plus Environment

4

Page 5 of 18

Environmental Science & Technology Letters

84

example, Kotthoff et al.1 reported 6:2 FTOH concentrations obtained using extractions procedures

85

that included product evaporation to dryness followed by reconstitution prior to analysis.

86

Our objective here is to demonstrate that an iodide-adduct chemical ionization mass

87

spectrometer shows potential as a reliable method for direct detection of FTOHs and other PFAS

88

that have previously been difficult to detect in the gas phase at appropriate time resolution. We

89

attempt to illustrate that utility through instrument calibrations of FTOHs, PFCAs, and a PFECA,

90

and by directly sampling semivolatile PFAS emitted from four commercially available fluoro-

91

products: three fluorosurfactants and an aqueous film-forming firefighting foam. PFAS present in

92

those products for which corresponding standards were available were quantified, and additional

93

PFAS signals were identified by probable molecular compositions.

94 95

MATERIALS AND METHODS

96

Chemical Ionization Mass Spectrometry. A high-resolution time-of-flight chemical

97

ionization mass spectrometer (ToF-CIMS, Aerodyne Research Inc/TOFWERK AG) operated in

98

negative ion mode with iodide reagent ion chemistry was used for this study (see Table S1 and

99

Figure S1 for instrument details). This technique has been used previously to quantify inorganic

100

and polar organic atmospheric trace gases and offers online, direct, and fast measurements without

101

the need for lengthy collection, extraction, and/or derivatization prior to detection.17-19 Sample air

102

is drawn directly into the inlet where analyte species are ionized by forming molecular adducts

103

with the iodide reagent ion, a soft ionization process that typically preserves parent ions with little

104

fragmentation. Analyte ion detection occurs at the parent + iodide mass-to-charge ratio (m/Q), and

105

all signals were normalized to the total reagent ion signal (I- + I(H2O)-) and reported per million

106

counts per second (cps) of total reagent ion. As in other studies utilizing an iodide-adduct CIMS,

ACS Paragon Plus Environment

5

Environmental Science & Technology Letters

Page 6 of 18

107

the ion optics were tuned to maximize both the total ion current and the ratio of the iodide-water

108

cluster to iodide (I(H2O)-/I-).17 The latter was used as an indication of the collision-induced

109

molecular ion declustering potential, which we hoped to minimize thereby preserving parent ions.

110

Air containing the gas-phase analytes was sampled directly into the instrument at 2.1 L

111

min-1. Though the CIMS is capable of faster data acquisition (>1 Hz), full mass spectra (3 – 1132

112

Da) measured at 0.33 Hz were sufficient for the investigations presented here. Preliminary proof-

113

of-concept tests in which the CIMS sampled the headspace above neat FTOH, per-, and polyfluoro

114

carboxylic acid standards indicated that the instrument effectively detected these classes of

115

compounds, and that the volatility was such that they were present in significant gas-phase

116

quantities. Instrument calibrations were then performed on 4:2, 6:2, 8:2, and 10:2 FTOH; PFOA;

117

PFBA; and HFPO-DA. During calibrations, dilute solutions of the standards were prepared in ethyl

118

acetate with concentrations ranging from 1 – 18 ng µL-1, depending on the standard. During

119

calibrations, 1 – 10 µL of standard solution was injected onto a 47 mm diameter, 2.0 µm pore size

120

polytetrafluoroethylene (PTFE) filter (Pall Corporation) within a perfluoroalkoxy (PFA) polymer

121

filter holder (Savillex) placed immediately upstream of the CIMS inlet. Humidified clean air (50%

122

RH) was used as the dilution/carrier gas. Upon contact with the filter, analytes were continuously

123

volatilized into the CIMS, and signals were integrated until