Graphene Quantum Dots Embedded in Bi2Te3 Nanosheets To

Jan 10, 2017 - In a typical procedure, a GQDs solution (4 mg/mL) was first prepared as described in a previous report (Figure S1).(17) The Te precurso...
3 downloads 12 Views 3MB Size
Subscriber access provided by UB + Fachbibliothek Chemie | (FU-Bibliothekssystem)

Article

Graphene quantum dots embedded in Bi2Te3 nanosheets to enhance thermoelectric performance Shuankui Li, Tianju Fan, Xuerui Liu, Fusheng Liu, Hong Meng, Yidong Liu, and Feng Pan ACS Appl. Mater. Interfaces, Just Accepted Manuscript • DOI: 10.1021/acsami.6b14274 • Publication Date (Web): 10 Jan 2017 Downloaded from http://pubs.acs.org on January 11, 2017

Just Accepted “Just Accepted” manuscripts have been peer-reviewed and accepted for publication. They are posted online prior to technical editing, formatting for publication and author proofing. The American Chemical Society provides “Just Accepted” as a free service to the research community to expedite the dissemination of scientific material as soon as possible after acceptance. “Just Accepted” manuscripts appear in full in PDF format accompanied by an HTML abstract. “Just Accepted” manuscripts have been fully peer reviewed, but should not be considered the official version of record. They are accessible to all readers and citable by the Digital Object Identifier (DOI®). “Just Accepted” is an optional service offered to authors. Therefore, the “Just Accepted” Web site may not include all articles that will be published in the journal. After a manuscript is technically edited and formatted, it will be removed from the “Just Accepted” Web site and published as an ASAP article. Note that technical editing may introduce minor changes to the manuscript text and/or graphics which could affect content, and all legal disclaimers and ethical guidelines that apply to the journal pertain. ACS cannot be held responsible for errors or consequences arising from the use of information contained in these “Just Accepted” manuscripts.

ACS Applied Materials & Interfaces is published by the American Chemical Society. 1155 Sixteenth Street N.W., Washington, DC 20036 Published by American Chemical Society. Copyright © American Chemical Society. However, no copyright claim is made to original U.S. Government works, or works produced by employees of any Commonwealth realm Crown government in the course of their duties.

Page 1 of 30

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

ACS Applied Materials & Interfaces

Graphene Quantum Dots Embedded in Bi2Te3 Nanosheets to Enhance Thermoelectric Performance Shuankui Li, a† Tianju Fan, a† Xuerui Liu, a Fusheng Liu, b Hong Meng, a Yidong Liu, a* and Feng Pana* a

School of Advanced Materials, Peking University Shenzhen Graduate School, Shenzhen,

518055, China. E-mail: [email protected] (Prof. F. Pan) b

College of Materials Science and Engineering, Shenzhen University and Shenzhen Key

Laboratory of Special Functional Materials, Shenzhen, 518060, China. KEYWORDS: Thermoelectric materials, Graphene quantum dot, Hybrid nanostructure, Charged interface, Phonon scattering ABSTRACT: Novel Bi2Te3/Graphene quantum dot (Bi2Te3/GQDs) hybrid nanosheets with a unique structure that GQDs homogeneously embedded in the Bi2Te3 nanosheet matrix have been synthesized by a simple solution-based synthesis strategy. A significantly reduced thermal conductivity and enhanced powder factor are observed in the Bi2Te3/GQDs hybrid nanosheets, which is ascribed to the optimized thermoelectric transport properties of the Bi2Te3/GQDs interface. Furthermore, by varying the size of GQDs, the thermoelectric performance of Bi2Te3/GQDs hybrid nanostructures could be further enhanced, which could be attributed to the optimization of the density and dispersion manner of GQDs in the Bi2Te3 matrix. A maximum ZT of 0.55 is obtained at 425 K for the Bi2Te3/GQDs-20nm, which is higher than that of Bi2Te3

ACS Paragon Plus Environment

1

ACS Applied Materials & Interfaces

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Page 2 of 30

without hybrid nanostrucure. This work provides the insights for the structural design and synthesis of Bi2Te3-based hybrid thermoelectric materials, which will be important for future development of broadly functional material system. 1. Introduction Bismuth telluride and their solid solutions are some of the most efficient thermoelectric materials near the room-temperature, but they are still not widely applied in useable thermoelectric devices because of the poor energy conversion efficiency.1-3 The conversion efficiency is characterized by the dimensionless figure-of-merit ZT= (S2σ/ҡ)T, where S, σ, ҡ, T are the Seebeck coefficient, electrical conductivity, total thermal conductivity, and absolute temperature, respectively. Obviously, an excellent thermoelectric material should have large power factor (S2σ) as well as low thermal conductivity, which is difficult to achieve in conventional material because of the interdependence of these three physical parameters.4-5 However, as the decreasing of the material dimensionality from conventional micro to nanometer, the new variable of length scale becomes available for controlling materials thermoelectric properties, which might allow new opportunities to optimize the three physical parameters independently. Extensive efforts have been made to controllable synthesis of Bi2Te3-based nanostructures. Various nanomaterials, such as nanowire,6 nanorod,7 nanoplates/nanosheets,8 nano-heterostructures, have been developed to improve their thermoelectric performances. 9-10 Moreover, constructed hybrid nanostructure with domain size comparable to or smaller than the carriers’ mean free path and/or coherence length is another promising way to realize the ballistic/coherent transport of heat and charge carriers. Unfortunately, limited works have been reported on the design and synthesis of Bi2Te3-based hybrid nanostructures with well-controlled components and interfaces to achieve simultaneously large power factor and low thermal conductivity.

ACS Paragon Plus Environment

2

Page 3 of 30

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

ACS Applied Materials & Interfaces

Graphene quantum dots (GQDs), a class of zero-dimensional carbon nanoparticles with typical dimensions of ca