Iridium-Catalyzed Regio- and Enantioselective Allylation of Ketone

Nov 15, 2005 - Synthesis of Optically Active Bifunctional Building Blocks through ..... Manfred Braun , Thorsten Meier , Frank Laicher , Panos Meletis...
0 downloads 0 Views 60KB Size
Published on Web 11/15/2005

Iridium-Catalyzed Regio- and Enantioselective Allylation of Ketone Enolates Timm Graening and John F. Hartwig* Department of Chemistry, Yale UniVersity, P.O. Box 208107, New HaVen, Connecticut 06520-8107 Received September 27, 2005; E-mail: [email protected]

Enantioselective allylic alkylation of ketone enolates is much less developed than the enantioselective additions of more stabilized nucleophiles derived from 1,3-dicarbonyl compounds.1 Enantioselective additions of ketone enolates to the less-hindered position of allyl electrophiles, as well as to symmetrically substituted allyl electrophiles, are known,2 but enantioselective reactions of unstabilized enolates that form chiral, branched substitution products from unsymmetrical allylic electrophiles (eq 1)3 have not been reported. Moreover, the formation of the same products by a more classical aliphatic Claisen rearrangement has not yet been accomplished as a catalytic enantioselective process.

The metal-catalyzed asymmetric allylation of unstabilized ketone enolates is challenging because the nucleophile must preferentially attack the π-allyl intermediate over the carbonyl group of the product, the ketone product must resist re-formation of an enolate followed by reaction with a second allyl electrophile, and reactions of monosubstituted allylic substrates must occur regioselectively at the more substituted terminus of an allyl intermediate. We have now found that reactions of allylic carbonates with silyl enol ethers and a combination of CsF and ZnF2 additives catalyzed by metallacyclic iridium phosphoramidite complexes meet these challenges, and we report reactions of these enolates with achiral allylic carbonates to form chiral, branched homoallylic ketones with high regio- and enantioselectivity. To develop additions of silyl enol ethers with allylic electrophiles, we began by studying reactions catalyzed by metallacyclic iridium complexes that we have shown to catalyze allylic amination and etherification.4 These catalysts are formed by combining [Ir(COD)Cl]2 with particular phosphoramidite ligands and heating with an amine to induce cyclometalation.5 Reactions of silyl enol ethers alone did not form any allylation product. However, reactions containing a series of metal fluorides revealed that the silyl enol ether 1a derived from acetophenone reacted with tert-butyl cinnamyl carbonate (2a) in the presence of CsF.6 Although the reactions with CsF occurred with modest selectivity (entry 2, Table 1), the reactions with a combination of ZnF2 and CsF occurred with much higher selectivity (entries 3-5 of Table 1). No reaction occurred when only ZnF2 was added (entry 1, Table 1). Reactions with substoichiometric amounts of CsF formed little of the diallylation product. Although the reactions with only 0.05 equiv of CsF required 3 days (entry 4), reactions with a ratio of enolate 1a to CsF to ZnF2 of 1.2:0.2:1.2 occurred to completion within 18 h, with a high branched-to-linear regioselectivity (93:7) and without formation of amounts of diallylation product detectable by 1H NMR spectroscopy (entry 5). Because the activated, cyclometalated catalyst could also be generated in situ (vide infra), reactions also occurred without preactivation of the catalyst, and these reactions went to completion with a ratio of 1a to CsF to 17192

9

J. AM. CHEM. SOC. 2005, 127, 17192-17193

Table 1. Effect of CsF and ZnF2 on the Ir-Catalyzed Allylation of Acetophenone Silyl Enol Ether 1aa

ratiob

molar ratios relative to 2a entry

1a

CsF

ZnF2

t (h)

1c 2c 3d 4d 5d 6c

1.2 1.2 1.5 1.2 1.2 1.5

1.2 1.5 0.05 0.2 0.4

1.2 1.5 1.2 1.2 1.5

24 24 24 72 18 8

%

conv.b

0 100 100 75 100 100

4a:5a:6a

60:17:23 78:8:14 87:11:2 92:7: