Subscriber access provided by READING UNIV
Article
Natural Attenuation of Nonionic Surfactants Used in Hydraulic Fracturing Fluids: Degradation Rates, Pathways, and Mechanisms Katie M. Heyob, Jens Blotevogel, Michael Brooker, Morgan Volker Evans, John J. Lenhart, Justin Wright, Regina Lamendella, Thomas Borch, and Paula J Mouser Environ. Sci. Technol., Just Accepted Manuscript • DOI: 10.1021/acs.est.7b01539 • Publication Date (Web): 06 Nov 2017 Downloaded from http://pubs.acs.org on November 8, 2017
Just Accepted “Just Accepted” manuscripts have been peer-reviewed and accepted for publication. They are posted online prior to technical editing, formatting for publication and author proofing. The American Chemical Society provides “Just Accepted” as a free service to the research community to expedite the dissemination of scientific material as soon as possible after acceptance. “Just Accepted” manuscripts appear in full in PDF format accompanied by an HTML abstract. “Just Accepted” manuscripts have been fully peer reviewed, but should not be considered the official version of record. They are accessible to all readers and citable by the Digital Object Identifier (DOI®). “Just Accepted” is an optional service offered to authors. Therefore, the “Just Accepted” Web site may not include all articles that will be published in the journal. After a manuscript is technically edited and formatted, it will be removed from the “Just Accepted” Web site and published as an ASAP article. Note that technical editing may introduce minor changes to the manuscript text and/or graphics which could affect content, and all legal disclaimers and ethical guidelines that apply to the journal pertain. ACS cannot be held responsible for errors or consequences arising from the use of information contained in these “Just Accepted” manuscripts.
Environmental Science & Technology is published by the American Chemical Society. 1155 Sixteenth Street N.W., Washington, DC 20036 Published by American Chemical Society. Copyright © American Chemical Society. However, no copyright claim is made to original U.S. Government works, or works produced by employees of any Commonwealth realm Crown government in the course of their duties.
Page 1 of 35
Environmental Science & Technology
1
Natural Attenuation of Nonionic Surfactants Used in Hydraulic Fracturing Fluids: Degradation
2
Rates, Pathways, and Mechanisms
3 4
Katie M. Heyob†, Jens Blotevogel‡, Michael Brooker†, Morgan Volker†, John J. Lenhart†, Justin
5
Wright , Regina Lamendella , Thomas Borch‡,||,§, and Paula J. Mouser*,†, ξ
6
⊥
†
7 8
⊥
Department of Civil, Environmental, and Geodetic Engineering, Ohio State University,
Columbus, Ohio 43210, United States ξ
9 10 11 12
Department of Civil and Environmental Engineering, University of New Hampshire, Durham,
NH 03824, United States ‡
Department of Civil and Environmental Engineering, ||Department of Soil and Crop Science,
§
Department of Chemistry; Colorado State University, Fort Collins, CO 80523, United States
⊥
13 14 15 16 17 18 19
Department of Biology, Juniata College, Huntingdon, PA 16652, United States
Keywords: alkyl ethoxylates, polyglycols, shale, Marcellus, nonylphenol, bacteria, diol dehydratase TOC ART
20
1 ACS Paragon Plus Environment
Environmental Science & Technology
21
ABSTRACT
22
Hydraulic fracturing fluids are injected into shales to extend fracture networks that
23
enhance oil and natural gas production from unconventional reservoirs. Here we evaluated the
24
biodegradability of three widely used nonionic polyglycol ether surfactants (alkyl ethoxylates
25
(AEOs), nonylphenol ethoxylates (NPEOs), and polypropylene glycols (PPGs)) that function as
26
weatherizers, emulsifiers, wetting agents, and corrosion inhibitors in injected fluids. Under
27
anaerobic conditions, we observed complete removal of AEOs and NPEOs from solution within
28
three weeks regardless of whether surfactants were part of a chemical mixture or amended as
29
individual additives. Microbial enzymatic chain shortening was responsible for a shift in
30
ethoxymer molecular weight distributions and the accumulation of the metabolite acetate. PPGs
31
bioattenuated the slowest, producing sizeable concentrations of acetone, an isomer of
32
propionaldehyde. Surfactant chain shortening was coupled to an increased abundance of the diol
33
dehydratase gene cluster (pduCDE) in Firmicutes metagenomes predicted from the 16S rRNA
34
gene. The pduCDE enzymes are responsible for cleaving ethoxylate chain units into aldehydes
35
before their fermentation into alcohols and carboxylic acids. This data provides new mechanistic
36
insight into the environmental fate of hydraulic fracturing surfactants after accidental release
37
through chain shortening and biotransformation, emphasizing the importance of compound
38
structure disclosure for predicting biodegradation products.
39 40
2 ACS Paragon Plus Environment
Page 2 of 35
Page 3 of 35
41
Environmental Science & Technology
INTRODUCTION
42
High volume hydraulic fracturing (HVHF) well completion methods involve the delivery
43
of 10-15 million liters of hydraulic fracturing fluid (HFF), composed of water and proppants
44
(approximately 99% by mass) along with chemical additives (1%), at high pressures into shale
45
formations to create fractures that enhance the extraction of oil and natural gas resources.1-3
46
Recent studies have informed our understanding of organic compounds present in injected fluids
47
and produced brines,4-7 including their inherent biodegradability and treatability.8-12 Much of the
48
dissolved organic carbon (DOC) that constitutes additive pollutants within a typical HFF is
49
quickly biodegraded (59% within 250 mg/L DOC) and mixed overnight (Table S1). Similarly, each of the four
123
amendments (corrosion inhibitor, stimulation surfactant, polypropylene glycol (average
124
molecular weight 425, Sigma Aldrich, St. Louis, MO) or propylene glycol (Thermo Fisher
125
Scientific (Waltham, MA))) were combined with groundwater to a concentration of 350 mg/L
126
total DOC and used in experiments within 24 hours.
127 128
Anaerobic microcosm studies were conducted using Bennington silty loam collected as
129
2-foot cores into sterile mason jars from soils adjacent to the airplane deicing pad at the Port
130
Columbus International Airport in Franklin County, Ohio (GPS coordinates: 40.02 N 83.01 W).
131
This location was specifically chosen to target microbial communities in former agricultural soils
6 ACS Paragon Plus Environment
Page 6 of 35
Page 7 of 35
Environmental Science & Technology
132
that were pre-acclimated to polyglycol compounds in order to diminish potential toxicity issues
133
and reduce acclimation times to these compounds (i.e., best-case biodegradation scenario). The
134
total organic carbon content of the sieved soil was 19 g/kg, the electrical conductivity was 299
135
µS, and the pH was 7.4 based on a 1:1 Milli-Q water dilution41 and Orion probe measurements
136
calculated prior to use. Particle size analysis of homogenized, sieved (2 mm mesh opening) soil
137
cores showed the soil was 4% sand, 60% silt and 36% clay. A total of 20 g sieved soil and 100
138
mL of amendment solution (SFF, stimulation surfactant, corrosion inhibitor, polypropylene
139
glycol, propylene glycol, and/or raw groundwater) was added to bottles for a final 1:5 solid-to-
140
liquid ratio. To achieve anaerobic conditions, liquids and solids were gassed with a 80:20 gas
141
mixture containing N2 and CO2 for fifteen minutes. Bottles were then capped with rubber septa
142
and crimp sealed, and headspace was gassed an additional fifteen minutes. Anaerobic conditions
143
were confirmed through measurements of dissolved oxygen and other reduced chemical species
144
(e.g. Fe(II)). Abiotic controls were autoclaved three times over a period of one week to de-
145
activate cells and spores. All bottles were placed on a Thermo Scientific MaxQ 3000 shaker
146
table at 75 rpm in the dark and held at 15 °C until sampling.
147 148
Analysis of Dissolved Oxygen, pH, Chloride, Fe, Organic Carbon, and Organic Acids
149
Solution pH and dissolved oxygen (DO) were measured on unfiltered samples using
150
Orion Star probes (Thermo Fisher Scientific, Waltham, MA) calibrated prior to use. Changes in
151
iron were monitored on unfiltered samples with a HACH DR/890 colorimeter (Loveland, CO)
152
using method 8008.42 Filtered samples (PES 0.22 µm pore size, EMD Millipore, Billerica, MA)
153
were used for analysis of chloride and organic constituents. Chloride, acetate, and propionate
154
were analyzed by Ion Chromatography using a Dionex ICS 2100 and IonPac AS11-HC column
7 ACS Paragon Plus Environment
Environmental Science & Technology
155
at 35 °C at a flow rate of 1.5 mL/min and cell temperature of 30 °C. After acidification (pH