Practical synthesis of semibullvalene - The Journal of Organic

1 Aug 1980 - James R. Behling , Kevin A. Babiak , John S. Ng , Arthur L. Campbell , Robert. Moretti , Mike. Koerner , Bruce H. Lipshutz. Journal of th...
0 downloads 0 Views 267KB Size
351 1

J . Org. C h e m . 1980, 45, 3511-3512

Notes Practical Synthesis of Semibullvalene'

1).

The method is one of simplicity and essentially

Nicolas J. Turro and Jong-Min Liu

Department of Chemistry, Columbia University, New York, New York 10027 Howard E. Zimmerman* and Ronda E. Factor

Department of Chemistry, University of Wisconsin, Madison, Wisconsin, 53706 Received March 24, 1980

Semibullvalene was first synthesized by Zimmerman and Grunewald in 19662by the sensitized irradiation of barrelenea3 Although straightforward, the synthesis requires six steps to reach barrelene. Since that time, four additional syntheses of semibullvalene have been reported. Thus, a second synthesis was described simultaneously by Meinwald4 and Zimmerman.5 This involved the room-temperature thermal rearrangement of tricyclo[ 3.3.0.O2l6]octa-3,7-diene to semibullvalene. The unstable diene is obtained by photochemical intramolecular [2+ 21 cycloaddition of 1,5-cycl~octadiene~ followed by freeradical chlorination to afford a dichloride which was dehydrochlorinated. The method is practical but limited by 25-40% yields in the several steps. A third synthesis7 utilized the sensitized photolysis of 2,3-diazotetracyclo[4.4.0.04~10.05~7]deca-2,8-diene7 which was obtained in three steps from barrelene. An alternative route to the diazatetracyclic precursor has been described by Askanis This alternative used five steps from cyclooctatetraene. A fourth synthesis using cyclooctatetraene and diethyl azodicarboxylate and requiring five synthetic steps led to semibullvalene in 24% yieldag The last synthesislo utilized the irradiation of cyclooctatetraene at -50 "C. While of preparative value, the method afforded benzene as an appreciable byproduct. Higher temperature solution-phase photolysis did not lead to semibullvalene. Results and Discussion A very practical synthesis of semibullvalene was found in the vapor-phase irradiation of cyclooctatetraenel' (eq (1)This paper is no. 125 of the Zimmerman photochemical series. (2) Zimmerman, H. E.; Grunewald, G.L. J . Am. Chem. SOC. 1966,88,

183-184. (3)(a) Zimmerman, H.E.; Paufler, R. M. J . Am. Chem. SOC. 1960,82, 1514-1515. (b) Zimmerman, H.E.; Grunewald, G.L.; Paufler, R. M.; Sherwin, M . A. Ibid. 1969, 91, 2330-2338. (4)Meinwald, J.; Schmidt, D. J . Am. Chem. SOC. 1969, 91, 5877. (5)Zimmerman, H.E.:Robbins, J. D.; Schantl, J. J . Am. Chem. SOC. 1969, 91, 5878-5879. ( 6 ) Srinivasan, R. J.Am. Chem. SOC. 1964, 86, 3318-3321. (7)Zimmerman, H.E.;Boettcher, R. J.; Buehler, N. E.; Keck, G. E.; Steinmetz, M. G. J . Am. Chem. SOC. 1976, 98, 7680-7689. (8)Askani, R.; Gurang, I.; Schwertfeger, W. Tetrahedron Lett. 1975, 1315-1318. (9) (a) Askani, R. Tetrahedron Lett. 1970, 3349-3350. (b) Note a 1970, 92, similar approach by: Paquette, L. A. J. Am. Chem. SOC. 5765-5767. This affords a 47% yield beginning with the formal adduct of N-phenyltriazolinedione and cyclooctatetraene. (IO) Zimmerman, H. E.; Iwamura, H. J . Am. Chem. SOC.1970, 92, 2015-2022.

quantitative yield. The main requisites of the synthesis are (1)a light source about 300 nm where cyclooctatetraene but not the semibullvalene product absorbs and (2)experimental conditions where reactant cyclooctatetraene is not permitted to absorb ultraviolet light while a liquid. Either a 450-W Hanovia lamp with a Pyrex filter or a Rayonet-type apparatus with 350 f 30-nm lamps may be used. The extent of product formation is limited only by the total amount of light utilized and thus by the reaction time. Our earlier publicationlopresents an extended discussion of mechanistic pathways leading to semibullvalene from cyclooctatetraene, and the present publication primarily contributes synthetically. Experimental Section Three lOO-mL, one-necked flasks with 24/40 ground-glassjoinb and a 4L beaker (25 cm high and 18 cm in diameter) are employed for the photolysis. The source of ultraviolet is a Hanovia 450-W, medium-pressure, mercury lamp and immersion-well apparatus. A Pyrex filter cylinder is used around the lamp to filter out wavelengths below 300 nm. Into each flask is added 100 mg (0.96 mmol) of cyclooctatetraene. Each flask is sealed under vacuum by first being cooled in a dry ice/acetone bath followed by subsequent application of a 0.05-mm vacuum. The lamp well is immersed in the center of the beaker filled with water maintained at 70 O C . The beaker is surrounded by aluminum foil which servm as a reflector. The flasks containing the cyclooctatetraene are placed in the water in proximity to the lamp well and irradiated for 60 h at 70 OC. After termination of photolysis, the product is distilled to the bottom of each flask by application of a dry ice/acetone bath to the flask bottoms, followed by removal by pipet. The totalcrude product weighs 0.26 g and is found by 100-MHz NMR and IR (CHCl, solution) analyses to consist of 298% semibullvalene,with traces (