Selective detector for gas chromatography based on adduct-modulated ... Bulk IIâVI and IIIâV Semiconductors and Implications for Chemical Sensing...
venient, a Knu-Vise No. V-400,E, was fitted with a clamp to hold the Lucite tube, and placed on an aluminum block behind the water bath (see Figure 1).
Optimization Using an Experimental Design. D. Deruaz , A. Bannier , C. Pionchon , M. S. Boukraa , W. Elbast , J. L. Brazier. Analytical Letters 1995 28 (11), 2095- ...
Jeffrey W. Long and Royce W. Murray. Inorganic Chemistry 1999 38 (1), 48-54. Abstract | Full ... Iron Porphyrin Chemistry. F. Ann Walker , Ursula Simonis. 2011, ...
little difficulty. There are two possible solutions to the problem of selective chromatographic detection. One would involve a dual- channel spectral analyzer ...
Jul 3, 1998 - Jeffrey W. Long and Royce W. Murray. Inorganic Chemistry 1999 38 (1), 48- ... Iron Porphyrin Chemistry. F. Ann Walker , Ursula Simonis. 2011, ...
a detector in gas chromatography. It gives a detector instrument of very rapid response, high stability, high sensitivity, and broad applicability, which is insensitive ...
Jul 15, 1994 - Thomas B. Ryerson, Andrew J. Dunham, Robert M. Barkley, and Robert E. Sievers*. Department of Chemistry and Biochemistry, CIRES, and ...
many investigations focused on plasma torch geometry (7-9). It should be noted that the residence time of analytes in the detection volume can be increased ...
Sulfur-Selective Detector for Liquid Chromatography Based on Sulfur Monoxide-Ozone Chemiluminescence. Thomas B. Ryerson, Andrew J. Dunham, Robert M.
cision of the peak area measurements made with temperatureprogrammed capillary columns: the relatively small area of the sharp peaks, and the baseline drift ...
