This is an open access article published under an ACS AuthorChoice License, which permits copying and redistribution of the article or any adaptations for non-commercial purposes.
Addition/Correction pubs.acs.org/IECR
Correction for “Spinning of Cellulose Nanofibrils into Filaments: A Review” Meri J. Lundahl,*,† Ville Klar,‡ Ling Wang,† Mariko Ago,† and Orlando J. Rojas*,† †
Department of Bioproducts and Biosystems, Aalto University, P.O. Box 16300, 00076 Aalto, Finland Department of Mechanical Engineering, Aalto University, P.O. Box 14100, 00076 Aalto, Finland
‡
Ind. Eng. Chem. Res. 2017, 56 (1), 8−19 (DOI: 10.1021/acs.iecr.6b04010) Page 14: In section 5.2, “Filament Drawing”, in the sixth paragraph of the section,1 the value cited for the production speed is wrong and, thus, the discussion based on it is also incorrect. The correct presentation for the final four sentences of this paragraph should be as follows: Furthermore, a production speed of 660 m/min has been achieved.26 This is already higher than the typical spinning rate in a single orifice in a viscose spinning line (20−150 m/min).42 Even higher production rates can be achieved through multiple spinnerets. For example, a typical viscose spinning line comprises 150− 400 individual spinnerets, each containing 1500−14000 orifices.42
■
REFERENCES
(1) Lundahl, M. J.; Klar, V.; Wang, L.; Ago, M.; Rojas, O. J. Spinning of cellulose nanofibrils into filaments: A review. Ind. Eng. Chem. Res. 2017, 56 (1), 8−19.
Published: March 28, 2017 © 2017 American Chemical Society
4205
DOI: 10.1021/acs.iecr.7b01194 Ind. Eng. Chem. Res. 2017, 56, 4205−4205
