Bio-oil Production by Thermochemical Catalytic ... - ACS Publications

Nov 14, 2017 - The liquefaction conditions were optimized by central composite design (CCD) experiments as follows: concentrated H2SO4 content, 6.6%; ...
0 downloads 0 Views 1MB Size
Subscriber access provided by University of Florida | Smathers Libraries

Article

Bio-oil production by thermochemical catalytic liquefaction of bloom-forming cyanobacteria: Optimization using response surface methodology (RSM) Fanghua Li, Zhiquan Hu, and Bo Xiao Energy Fuels, Just Accepted Manuscript • DOI: 10.1021/acs.energyfuels.7b02595 • Publication Date (Web): 14 Nov 2017 Downloaded from http://pubs.acs.org on November 19, 2017

Just Accepted “Just Accepted” manuscripts have been peer-reviewed and accepted for publication. They are posted online prior to technical editing, formatting for publication and author proofing. The American Chemical Society provides “Just Accepted” as a free service to the research community to expedite the dissemination of scientific material as soon as possible after acceptance. “Just Accepted” manuscripts appear in full in PDF format accompanied by an HTML abstract. “Just Accepted” manuscripts have been fully peer reviewed, but should not be considered the official version of record. They are accessible to all readers and citable by the Digital Object Identifier (DOI®). “Just Accepted” is an optional service offered to authors. Therefore, the “Just Accepted” Web site may not include all articles that will be published in the journal. After a manuscript is technically edited and formatted, it will be removed from the “Just Accepted” Web site and published as an ASAP article. Note that technical editing may introduce minor changes to the manuscript text and/or graphics which could affect content, and all legal disclaimers and ethical guidelines that apply to the journal pertain. ACS cannot be held responsible for errors or consequences arising from the use of information contained in these “Just Accepted” manuscripts.

Energy & Fuels is published by the American Chemical Society. 1155 Sixteenth Street N.W., Washington, DC 20036 Published by American Chemical Society. Copyright © American Chemical Society. However, no copyright claim is made to original U.S. Government works, or works produced by employees of any Commonwealth realm Crown government in the course of their duties.

Page 1 of 24

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Energy & Fuels

1

Bio-oil production by thermochemical catalytic liquefaction of bloom-

2

forming cyanobacteria: Optimization using response surface methodology

3

(RSM)

4

Fanghua Li1,2, Zhiquan Hu1*, Bo Xiao1

5

1. School of Environmental Science and Engineering, Huazhong University of Science and

6

Technology, 1037 Luoyu Road, Wuhan 430074, China

7 8 9 10

2. Department of chemical engineering, Monash University, Wellington Rd, VIC 3800, Australia

11

Fax: +86-27-87557464. E-mail: [email protected] (Z. Hu),

* To whom correspondence should be addressed. Phone: +86-27-87557464.

12 13

Abstract

14

Experimental research on thermochemical catalytic liquefaction of bloom-forming

15

cyanobacteria (BC) was carried out to determine the effects of solvent, catalyst, reaction

16

time, temperature, the ratio of raw material to solvent and catalyst dosage on liquefaction

17

performance. The liquefaction conditions were optimized by central composite design (CCD)

18

experiments as follows: the concentrated H2SO4 content of 6.6%, the reaction temperature of

19

175°C, the reaction time of 30 min and the ratio of material to solvent of 1:4. The

20

liquefaction yield and oil yield (chloroform phase) reached 93.85% and 37.96% at above-

21

mentioned conditions. The ultimate analysis and calorific value of the oil were determined,

22

and the chemical composition of the oil was investigated using gas chromatography-mass

23

spectrometry (GC-MS) technique and Fourier-transform infrared (FT-IR) spectroscopy. The

24

analysis of bio-oil composition showed that bio-oil from BC mainly contains ethyl palmitate

25

which is the main composition of palm oil biodiesel, with a heating value of 32.7MJ/kg.

26

Keywords: Bio-oil production; Bloom-forming cyanobacteria; Thermochemical catalytic

27

liquefaction; Bio-oil characterization

1

ACS Paragon Plus Environment

Energy & Fuels

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

28 29 30

1. Introduction

31

the current society. The reserves of fossil fuel are decreasing gradually; this reduction is

32

coupled with an increase in greenhouse gas emissions (mainly CO2) contributing to global

33

warming. Thus, it is essential to develop a process to reduce the emissions of greenhouse

34

gases. This requirement has led to an increasing interest in the utilization of renewable

35

sources. Biomass, as a renewable source, will play an important role in sustainable energy

36

systems due to being non-toxic, biodegradable and environment-friendly. Compared with the

37

terrestrial biomass, the aquatic biomass (such as algae) possessed the advantages of rapid

38

growth, high photosynthetic efficiency, high lipid productivity, capability of capturing flue

39

gas, especially CO2, tolerance to a wide range of water sources, potential to provide

40

transportation fuels and no competition with arable land [1]. Therefore, there had been a

41

growing interest in using algae as a promising candidate for biofuel production [2]. In recent

42

decades, there is an increasing concern of lake eutrophication in China. Sixty-six percent of

43

the lakes are at the level of over eutrophication and the lakes at severe and extreme

44

eutrophication level constitute 22% of the total lakes [3]. Lake Dianchi ranked number six in

45

the case of area among all the freshwater lakes in China and located in Kunming City,

46

Yunnan Province, Southwestern of China.

47

cyanobacteria (BC) have appeared frequently in Lake Dianchi due to the raise of heavy

48

eutrophication. Because of the heavy metals and toxins in algal cells, heavy BC posed a

49

threat to human and animal health and was not available for food and feed [4]. As a result, it

50

is quite necessary to remove BC as a reduction of nitrogen and phosphorus level in the lake in

51

order to remediate eutrophication of Lake Dianchi [5]. However, the large quantities of

52

harvested bloom algae can cause serious secondary-environmental pollution without an

53

effective technology for converting the collected biomass. Thus, using the large amounts of

54

biomass collected from eutrophic lakes as feedstock for useful products may be a promising

55

solution [6].

56 57

Recently, many researches have been carried out to recover energy from algae through

58

thermochemical technologies, including gasification [7], direct combustion [8], pyrolysis [8-

59

12] and liquefaction [13]. Among them, efforts on liquefaction of algae are quite limited. In

60

the open literatures, Huang et al. [14] studied the thermochemical liquefaction of Spirulina

61

with the solvent of sub- and supercritical ethanol in an autoclave. Various liquefaction

62

parameters were investigated such as the reaction temperature, the ratio of solid to liquid, the

Energy shortage and environmental pollution problems are the most significant issues facing

At present, large area bloom-forming

2

ACS Paragon Plus Environment

Page 2 of 24

Page 3 of 24

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Energy & Fuels

63

solvent filling ratio, and the type and dosage of the catalyst. They found that the bio-oil yield

64

increased generally with increasing temperature and solvent filling ratio, while the bio-oil

65

yields reduced with increasing solid to liquid ratio. The FeS catalyst played an important role

66

in the liquefaction of Spirulina due to its contribution on the production of bio-oil and the

67

reduction of residue. Under catalytic liquefaction, the liquid products showed higher heating

68

values than non-catalytic liquefaction and the dominant compounds in bio-oil were fatty acid

69

ethyl ester for both catalytic and non-catalytic liquefaction. Xu et al. [15] investigated the

70

bio-oil production from planktonic algae biomass by thermochemical catalytic liquefaction

71

with the catalyst of NaOH. Reaction conditions such as reaction time, temperature and the

72

ratio of algae to solvent were explored. With the increase of reaction time and temperature,

73

the liquefaction yield increased first and then decreased. The maximum liquefaction yield

74

was 61.6%. The chemical components of the bio-oil including acid, ester derivatives, furan

75

and phenol were reported. Zou et al. [16] investigated the thermochemical catalytic

76

liquefaction of Dunaliella tertiolecta in the solvent of ethylene glycol with H2SO4 as a

77

catalyst. They achieved 97.05% of liquefaction yield from the microalgae. The main bio-oil

78

compositions were fatty acid methyl ester, fatty acid hydroxyethyl ester and benzofuranone.

79 80

However, the main issue of these studies is the energy-consuming process of cultivation,

81

especially the laboratory-grown cultures [17-20], which hinders the commercial application

82

of bio-oils produced by thermochemical liquefaction. Pyrolysis conversion of BC into bio-oil

83

had been carried out in our previous study [21]. The results showed that the BC had a great

84

potential for transportation fuel production, however, there was a low bio-oil yield with an

85

energy intensive process. After the experiments, there was still a large portion of the residual

86

solid left as waste. Therefore, it is necessary to find an approach by which the algae sample

87

can be converted with higher yields. Up to date, there were few reports, if any, were

88

concerned on particular liquefaction characteristics of BC under different reaction

89

parameters, which is just the point to be explored in depth in this paper.

90 91

The aims of this study are to (1) examine the effects of solvent and catalyst, reaction time,

92

temperature, ratio of material to solvent and catalyst dosage on the product yields, (2)

93

understand the properties and composition of bio-oil obtained under the conditions of

94

maximum liquid yield, (3) evaluate the potential of bio-oil produced from BC as a potential

95

source of renewable fuel.

96 97

2. Materials and methods 3

ACS Paragon Plus Environment

Energy & Fuels

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

98 99 100 101

2.1. Raw materials and sample preparation In this study, BC biomass used as the raw material, mainly comprised of Microcystis species

102

(>90%), was collected from Lake Dianchi of Yunnan Province in China and dried under

103

natural summer sunlight for 7 days. Before the experiment, the preserved algae biomass was

104

dried again in an oven at 60 °C overnight. The dried biomass obtained was sieved (