Cationic Polymerization of a-Methylstyrene

the method of Meissner and Reddingg to be 222.0'. This temperature must be quite near the true critical temperature, since vapor pressure measure- men...
0 downloads 0 Views 418KB Size
CATHIONIC POLYMERIZATION OF (u-METHYLSTYRENE

Sept. 20, 1957

the method of Meissner and Reddingg to be 222.0'. This temperature must be quite near the true critical temperature, since vapor pressure measurements a t 220' were exceedingly difficult to make. For the temperature range 110-210', log p is approximately a linear function of the reciprocal of the absolute temperature; the value a t 220' was not included in the derivation of the relationship log p (atm.) = 4.3609386 1409*0428 273.16)

(T

+

+ 0.000244348( T + 273.16)

where T i s in 'C. The maximum deviation between the experimental vapor pressure and the vapor pressures cal(9) € P. I . Meissner and E. M. Redding, I n d . Eng. Chem., 34, 521 (1942).

[CONTRIBUTIONFROM

THE

4917

culated by the above equation is o.30y0; this equation reproduces 9 of the 11 experimental points to 0.15y0or less. The compressibility values are believed to be accurate t o within 0.1 to 0.2%. The decomposition of 1,2-difluoro-l,1-dichloroethane proceeded slowly enough even a t the highest temperatures to provide accurate P-V-T data; the vapor pressure values are changed more by a slight decomposition than are the compressibility values. Acknowledgment.-This work was made possible, in part, by a grant from the Defense Research Laboratory, The University of Texas, under the sponsorship of the Bureau of Ordnance, Navy Department, Contract NOrd-9195, for which the authors express their gratitude. KINGSVILLE, TEXAS

DIVISIONO F APPLIED CHEMISTRY, NATIONAL RESEARCH COUNCIL (CANADA)]

Cationic Polymerization of a-Methylstyrene BY D. J. WORSFOLD AND S. BYWATER RECEIVED APRIL26, 1957 The kinetics of polymerization of a-methylstyrene with a boron trifluoride-ether-water complex have been studied. The reaction rate has bee" found to be governed by the expression - d[M]/dt = ki[c] [MI (2 kp[M]/kt) and the degree of k,[M]/k,. The nature of the termination step has been investigated. The cause cf the low polymerization by D P = 2 degree of polymerization has been identified as a low propagation rate compared with the termination reaction.

+

The heat of polymerization of a-methylstyrene is known to be only of the order of 8 kcal. This would lead to the conclusion that the ceiling temperature for polymerization, as defined by Dainton and Ivin, would be somewhat above room temperature. It is known, moreover, that the radical polymerization of this monomer is very difficult and a t ambient temperature only low molecular weight polymers are produced with the Friedel-Crafts type of catalysts. It would seem desirable therefore to carry out kinetic measurements a t lower temperatures using cationic catalysis whereby rather higher molecular weight polymers are formed in order to determine more certainly the cause of the low degree of polymerization. The two principal previous studies of this reaction, one by Jordan and Mathiesoq2 using aluminum chloride in carbon tetrachloride solution and one by Dainton and Tomlinsona using stannic chloride in ethyl chloride solution, are so contradictory that the study of a third system would seem worthwhile. The system chosen was boron trifluoride etherate in the presence of excess water and diethyl ether in ethylene chloride solution. The kinetics were found to follow very closely the mechanism proposed by Dainton and Tomlinson for their system. Experimental Materials.-Ethylene chloride was stirred with concentrated sulfuric acid for four days, washed, dried and distilled from aluminum chloride, and after a final wash was fractionally distilled over phosphoric oxide. The product was degassed and stored under vacuum. (1) F. S. Dainton and K. J. Ivin, Nalure, 162, 705 (1948). (2) D.0.Jordan and A. R. Mathieson, J . Chem. Soc., 2354 (1952). (3) F. S. Dainton and R. H. Tomlinson, i b i d . , 151 (1953).

+

a-Methylstyrene was fractionally distilled under vacuum, and stored under vacuum. Boron trifluoride was sublimed under vacuum and stored a t liquid nitrogen temperature. Diethyl ether was distilled from sodium wire and then from phosphorus pentoxide into a trap on the vacuum system. Procedure.-Since it has been reported that cationic polymerizations are rendered more reproducible by having a fair excess of water present, the concentration of water in practically all runs was a t such a level that a very limited exposure to the atmosphere was considered permissible in that the water pick up would be negligible compared to the added water. Solutions of monomer and water in ethylene chloride and boron trifluoride and ether in ethylene chloride, were prepared under vacuum, and blanketed with dry nitrogen. The reaction was started by pipetting a little of the catalyst solution into the monomer solution. Samples were siphoned from the reaction vessel a t intervals and the residual monomer estimated with mercuric acetate in methanol s o l ~ t i o n . ~The initial rates were found from the first 10% or less of the reaction; rates given are in units of moles/l./minute. The molecular weights were determined after 10% reaction using the viscosity relationship, for benzene solution a t 30'. [vlapo/c = 0.0105 1.787 X 10-5 M obtained from cryoscopic measurements on unfractionated polymer samples.

+

Results The effect of temperature on the initial rates and degree of polymerization a t various monomer concentrations was investigated a t five temperatures between + Z O O and -20'. At +Zoo the initial rates are very nearly dependent on the first power of the monomer concentration (Fig. l ) , but a t the lower temperatures the order increases and the whole series is adequately described by the expression Initial rate = K1[M](C &[MI)

+

(4) R. W. Martin, Anal. Chem., 21, 921 (1949).

D. J. WORSFOLD AND S. BYWATER

4918

Vol. 79

are also linear a t these temperatures and extrapolate back to a value close t o 2 (Fig. 3). They are described by the equation DP = 2

+ Ks[M]

The variation of initial rate with boron trifluoride, water and ether concentrations was measured a t - 10' together with the corresponding degrees of polymerization, with the results shown in Tables 1, I1 and 111.

0

02

06

04

IO

08

12

TABLE I VARIATION OF INITIALRATEAND DP WITH [BFa] O ] 2.68 X lo-' M , [HzO] = 3.11 X 10-8 M , [ C ~ H ~ O = [GHIO]= 1 M , temp. = -10' -

14

10' X IBFIa

[MONOMER].

3.05 3.05 2.41 1.87 1.37 1.37 1.30 1.29 0.61

= 2.73 X

[HzO] = 3.11 X [C~HIOO] = 2.68 X lo-%.

Fig. 1.-[BFa]

and plots of initial rate/ [Monomer] against [Monomer] are linear (Fig. 2). Some deviations are found a t concentrations above molar in monomer a t

104 X initial rate

3 6.7 35.0 25.4 18.8 9.1

DP

1

15.5 15.2 15.7

7

i J

15.8

11.7 12.3 11.0 4.2

14.9

TABLE I1 VARIATION OF INITIALRATEAND DP WITH [HzO] [BF,] = 3.05 X lo-, M , [CcHioO] = 2.6: X lo-' hf, [C9Hlo]= 1 M , temp. = -10 _10' X

. '

/ 52

Temp

+10 0

- 10 - 20

04

08 [MO N 0 MER]

06

.

IO

I 2

4

0 2

06

06 OB [MONOMER],

2

0

4 '

Fig. 2 l o 3 X [BFa] l o 3 X [HzO] 1 0 2 X [C~HIOO] 1.09 3 11 2 68 1 09 3 11 2 41 9 33 2.68 3 05 3 11 1 25 1 09

the lower temperatures, but these probably are due to the considerable change in the environment a t these high concentrations. The plots of DP against monomer concentrations _/l

B

.L.

,/,' I

I

I

[MONOMER].

Fig. 3.-Reactant

concentrations as in Fig. 2.

1-J

[HIO] added

0 0 1.46 3.11 3.11 3.11 3.11 6.22 9.33 9.33 12.44

104 X initial rate

DP

1

18.7

i

15.5

78.3 119.5 33.0) 35.0 41.3 36.7 19.7

16.8

1 17.8

1

12.5

10.8 11.4 6.45

16.6

TABLE 111

VARIATION OF INITIAL RATEAND DP [HzO] = 3.11 X M , [BFa] 1.37 = 1 M , temp. = -10 IO* X [C~HIOO]

0 1.29 1.59 2.68 5.38

WITH

[C,HioOI M , [CaHlol

lo4 X initial rate

-

ca. 5000 93.5 52.7 12.3 2.98

(15.8) 19.6 19.2 15.8 13.1

DP

It is seen that both water and ether concentration have a large effect on the reaction, both considerably reducing the rate with increasing concentration in the range covered. I n the complete absence of ether, however, the rate achieves a very high value indeed. But as the water concentration decreases the rate becomes very variable and seems to level off or perhaps fall. The order with respect to boron trifluoride is rather greater than unity, but a simple relationship is perhaps not to be expected in this complex initiating system. The degree of polymerization shows far smaller variations than does the rate. It appears to be coini>letely independent of the boron trifluoride

Sept. 20, 1957

CATIONIC POLYMERIZATION OF a-METHYLSTYRENE

concentration, nearly independent of the water, and only decreases slowly with higher ether concentrations. These results tend to exclude the possibility of any transfer with water and to permit a very little with ether. The principal effect of varying these reactants is on the initiation reaction. ,411 reactions would go to completion and there was no evidence for catalyst or co-catalyst consumption.

Monomer transfer

P,+

Termination

Pn +

Monomer termination

P,+

49 19 kb + P + hl+

+M

ks + P + E[+

+ Ril

k7

--+

P

+W

where C is an active complex of BF3, water and ether, and I may be any transfer agent. The transfer reactions involving water or monoDiscussion mer can both be eliminated since they give kinetic The initiation of cationic polymerization is gen- equations which are either incompatible with the erally thought to occur through the reaction of the dependence of the initial rate or the degree of polymonomer with a proton donating complex of the merization with monomer concentration, or both. Friedel-Crafts catalyst with some protonated com- On the same grounds monomer termination can also pound such as water. I n this investigation when be eliminated. Solvent transfer cannot be elimiwater was present it is assumed that the initiating nated on kinetic grounds, but can be ignored since agent is some hydrate of boron trifluoride formed the polymer contained virtually no chlorine. Transfer with ether, however, is feasible, on kiin competition with the etherate. Two hydrates netic grounds, and the variation of degree of polymerhave been isolated, an unstable monohydrate, and a comparatively stable dihydrate.6 The structures ization with ether concentration a t - 10’ suggests that a t this temperature 2k3 kg. With the low suggested for the two complexes are H +(EFSOH) concentration of ether present, hcwever, this reacand (H3+0)(BF30H). Quite possibly the former tion can only play a minor role. It is possible that would be a stronger proton donating agent, and ac- the ether extracts the proton to form an oxonium count for the fall in rate as the water concentration ion. increases due to the formation of more of the dihyThe major part of the reaction, consequently, drate. It also has been suggested that water re- seems to be governed by the reactions 1, 2 and 6, acts with boron trifluoride etherate t o form a com- leading to the rate expressions similar ~),~ plex of structure (CzHbO+Hz)( ~ S F ~ O C Z H to that of the alcoholate, this too could be the initiating agent. It is possible that under rigorously dry conditions where [C] is the concentration of active catalyst the rate would fall t o zero, although solvent co- species, and catalysis and the more likely ether cocatalysis are k both feasible. There was little evidence for solvent DP = 2 2 [MI ks cocatalysis as a polymer of molecular weight 1600, formed with no water deliberately added to the re- Plots of initial rate/ [Monomer] and against action mixture, had less than 0.057, chlorine pres- monomer concentration should both be linear giving ent. The infrared spectrum of the polymer showed intercepts of 2kl[C! and 2, respectively, and this no evidence of ether linkages, but this in itself linearity is found. Also the ratio slope,/intercept would not eliminate the possibility of ether cocatal- and slope! 2 for the two equations respectively are ysis. both k2/2ks, and should be equal. These values The role of the ether probably is to reduce both from the experimental results are shown in Table the free boron trifluoride concentration and that of IV, where good agreement is found a t all except the the monohydrate in the form H+(BF30H)-, by highest temperature. solvating the proton.