Correction to Turnover Numbers, Turnover Frequencies, and

Efficient enantioselective degradation of the inactive ( S )-herbicide dichlorprop on chiral molecular-imprinted TiO 2. Ya-Nan Zhang , Weiguo Dai , Yu...
1 downloads 0 Views 246KB Size
Addition/Correction pubs.acs.org/JACS

Correction to Turnover Numbers, Turnover Frequencies, and Overpotential in Molecular Catalysis of Electrochemical Reactions. Cyclic Voltammetry and Preparative-Scale Electrolysis Cyrille Costentin, Samuel Drouet, Marc Robert, and Jean-Michel Savéant* J. Am. Chem. Soc. 2012, 134, 11235−11242. DOI: 10.1021/ja303560c Page 11236. A stoichiometric factor of 2, corresponding to the requirement that two molecules of catalyst are involved in the production of one molecule of product, was omitted in the original paper. Correction of this omission leads to the following changes in Scheme 1, several equations, and Figures 1, 2, and 6. Scheme 1

Figure 2. Catalysis and diffusion for a homogeneous catalytic reaction under preparative scale steady-state conditions.

Figure 6. TOF(2) vs overpotential Tafel lines for, from bottom to top, 0.1, 0.75, 3 M PhOH. The green segments are derived from 0.1 V/s experiments. The red, magenta, and blue segments shown for [PhOH] = 3M, were obtained at 1, 10, 50 V/s, respectively. The colored arrows indicate the length of the overpotential interval browsed at each scan rate. The yellow dots represent the electrolyses at −1.335, −1.36, and −1.385 V vs SHE (see text and Figure 7 in original paper).

then: Figure 1. Catalysis and diffusion for a heterogeneous catalytic reaction under preparative scale steady-state conditions.

CCb =

The turnover number is defined as the number of moles of substrate transformed by one mole of both forms of the catalyst present on the surface:

Page 11237. The latter concentration is thus obtained, from the combination of the various equations in Figure 1, as dCCb SD ⎛ dC ⎞ IS = − A ⎜ C⎟ = dt V ⎝ dx ⎠x = δ 2FV

TON = Cb × V kCA0 × t molC = C0 = F 0 ⎤ mol(P + Q) ΓP × S 1 + exp⎡⎣ RT (E − E PQ )⎦

Since, 2kCA0 Γ 0P I = F 0 ⎤ F 1 + exp⎡⎣ RT (E − E PQ )⎦ © 2012 American Chemical Society

kCA0 Γ 0P S ×t F 0 ⎤ V ⎡ 1 + exp⎣ RT (E − E PQ )⎦

Published: November 19, 2012 19949

dx.doi.org/10.1021/ja3106187 | J. Am. Chem. Soc. 2012, 134, 19949−19950

Journal of the American Chemical Society

Addition/Correction

and the turnover frequency (s−1): TOF =

kCA0

F 0 ⎤ 1 + exp⎡⎣ RT (E − E PQ )⎦

TON(2) =

TOF(2) =

TOF(2) =

k×t F 0 ⎤ ⎡ 1 + exp⎣ RT (E − E PQ )⎦

(1)

k F 0 ⎤ ⎡ 1 + exp⎣ RT (E − E PQ )⎦

(2)

k F 0 0 ⎡ 1 + exp⎣ RT (EAC − E PQ − η)⎤⎦

(4)

log TOF(2) = log k −

Fη F 0 0 − E PQ (EAC )+ RT ln 10 RT ln 10 (5)

The corresponding intrinsic turnover frequencies ensue as measures of the intrinsic properties of the catalyst + phenol system: TOF(2) = 3.1 × 10−8, 2.45 × 10−9, and 1.75 × 10−7 for [PhOH] = 0.1, 0.75, and 3 M, respectively. Page 11241. The values of the rate constant, 2k = 1.7 × 104 −1 −1 M s and TOF(2) = 0.8 × 10−6 M−1 s−1, are in good agreement with the values derived from the foot-of-the-wave analysis in CV (2k = 1.6 × 104 M−1 s−1, TOF(2) = 0.75 × 10−6 M−1 s−1) for the same concentration of PhOH.



ACKNOWLEDGMENTS We are indebted to Prof. Joe OTSUKI (College of Science and Technology, Nihon University, Tokyo, Japan) for making us aware of the stoichiometric factor problem.

19950

dx.doi.org/10.1021/ja3106187 | J. Am. Chem. Soc. 2012, 134, 19949−19950