Correspondence. Heat Transfer in Fluidized Beds. Comments

Ind. Eng. Chem. , 1967, 59 (4), pp 59–59. DOI: 10.1021/ie50688a012. Publication Date: April 1967. Note: In lieu of an abstract, this is the article'...
0 downloads 0 Views 137KB Size
CORRESPONDENCE Heat Transfer in Fluidized Beds Sir: The authors assume that Nu > 2 is necessarily correct. They then question all that has gone before as being inconsistent because it does not support their conclusions. Why should Nu > 2? The authors do not examine this aspect of the problem. If they had, they might be inclined to reconsider their conclusions. Consider conduction in a n infinite medium around a spherical, steady source of heat, q: q = -4 m 2 k ( d t / d r )

integrating, q = 4 rrk(t1 - t 2 ) / ( 1 / r 1 - l / r 2 ) ; as

r2 + m ,

.:

> rl

q --t 4 akrl(t1 - tz)

q = 4 rrr12h(tl

now,

r2

- tt)

hrI2 = krl, or hrl/k = 1, or hd.k = 2 = Nu

This seems to be the source of the rule, Nu > 2. Is it reasonable to conclude that particle-to-fluid heat transfer in a fluidized bed is governed solely by conduction in a stagnant medium? O r is it more reasonable, in the light of much research which indicates Nu < 2 , either to seek some rational explanation for the discrepancy or to present the results of a n experiment which shows Nu > 2? Let it be supposed, for the moment, that Nu > 2 . I t is not difficult to conceive of a plausible mechanism for the observed low coefficients. All it takes is agglomeration. That is not to say that agglomeration is the mechanism for the observed behavior. Agglomeration is just a handy postulate here, for the sake of argument. If the particles agglomerate to size D = nd, the necessity for Nu > 2 requires that the effective heat transfer coefficient for the agglomeration be less than that for a single particle (by the factor l / n ) . Also, the effective surface area presented by the agglomeration is less than the sum of the areas of the individual particles making up the agglomerates. Therefore, the product of effective heat transfer coefficient and effective heat transfer area is less for the agglomeration than for the individual particles. Further, for the same temperature difference, agglomeration transfers less heat and gives the appearance of low heat transfer coefficients for the individual particles. The requirement that Nu > 2 does not take into account motions by the particles or the fluid. Isn't it possible that there may be transient effects, brought about by the motions influencing the heat transfer? Only 17 of the references in the article by Barker, to which the authors refer, mention fluid-to-particle heat transfer coefficients. Those are the ones in Table I and in Figure 1 of that article. The text of that paper points out that 12 of those 17 should be considered as representative of relevant data.

While it is true that the great majority of fluid bed applications can dismiss the fluid-to-particle temperature difference as completely negligible, there are exceptions, particularly in the nuclear field. JAMES J. BARKER Consulting Engineer 70 Walden A m . Jericho, L . I., N . Y.

Professor Harriott's Refily Sir; For heat transfer from a single sphere to the surrounding fluid, the minimum Nusselt number is 2.0, corresponding to conductions in a n infinite stagnant medium. The heat transfer coefficient is based on the heat transferred per unit surface of the sphere and the temperature difference between the surface and the fluid a t infinity. If the particle is confined in an enclosure or if the fluid flows past the particle, the coefficient and the Nusselt number are increased. The question considered is: Are there any conditions under which heat transfer from a particle to the surrounding fluid would give a Nusselt number less than 2.0? Transient Effects. Introducing a particle into stagnant fluid at a different temperature gives rise to temperature transients. For short times, the instantaneous coefficient is large and varies with t-"', approaching the limiting value (NNu= 2 ) for long times. For a particle in a flowing stream, the corresponding solutions are not available, but exposing the particle to temperature cycles would probably always increase the average coefficient, since the solutions for very rapid cycling would approach that for a particle in stagnant fluid a t short contact times. Fluctuations in velocity, u, might lead to a lower coefficient, h, than a constant velocity, since h varies with a fractional power of u. However, the Nusselt number would never be less than 2.0, the limit for u = 0. Shape Effects. A single particle of approximately spherical shape but having a rough surface can have a Nusselt number less than 2.0 based on the total exterior surface. However, the Nusselt number based on the area of a sphere of the same nominal size would be 2.0 or greater. Irregular particles such as grains of sand may have 1.1 to 2 times as much surface as a sphere of the same nominal size and might therefore have minimum Nusselt numbers of 1.8 to 1 . This small effect is not a n explanation for the very low Nusselt numbers reported for fluidized beds. Agglomeration Effects. Two spheres touching each other will transfer less heat to a flowing or stagnant fluid than two widely separated spheres, and the minimum Nusselt number based on total area will be about 1.5 (the exact solution is given in a recent issue of Trans. VOL. 5 9

NO. 4

APRIL 1967

59