The Dissociation of Diacetyl: A Shock Tube and Theoretical Study

Jul 1, 2009 - Xueliang Yang,† Ahren W. Jasper,‡ John H. Kiefer,§ and Robert S. Tranter*,† ... Walters3 (383-436 K, 147-287 Torr) who studied th...
0 downloads 0 Views 892KB Size
8318

J. Phys. Chem. A 2009, 113, 8318–8326

The Dissociation of Diacetyl: A Shock Tube and Theoretical Study Xueliang Yang,† Ahren W. Jasper,‡ John H. Kiefer,§ and Robert S. Tranter*,† Chemical Sciences and Engineering DiVision, Argonne National Laboratory, 9700 South Cass AVenue, Argonne, Illinois 60439, Combustion Research Facility, Sandia National Laboratory, P.O. Box 969, LiVermore, California 94551, and Department of Chemical Engineering, UniVersity of Illinois at Chicago, 810 South Clinton Street, Chicago, Illinois 60607 ReceiVed: April 22, 2009; ReVised Manuscript ReceiVed: May 22, 2009

The dissociation of diacetyl dilute in krypton has been studied in a shock tube using laser schlieren densitometry at 1200-1800 K and reaction pressures of 55 ( 2, 120 ( 3, and 225 ( 5 Torr. The experimentally determined rate coefficients show falloff and an ab initio/Master Equation/VRC-TST analysis was used to determine pressure-dependent rate coefficient expressions that are in good agreement with the experimental data. From the theoretical calculations k∞(T) ) 5.029 × 1019 (T/298 K)-3.40 exp(-37665/T) s-1 for 300 < T < 2000 K. The laser schlieren profiles were simulated using a model for methyl recombination with appropriate additions for diacetyl. From the simulations rate coefficients were determined for CH3 + CH3 ) C2H6 and CH3 + C4H6O2 ) CH3CO + CH2CO + CH4 (k(T) ) 2.818T 4.00 exp(-5737/T) cm3 mol-1 s-1). Excellent agreement is found between the simulations and experimental profiles, and Troe type parameters have been calculated for the dissociation of diacetyl and the recombination of methyl radicals. Introduction The dissociation of diacetyl, 2,3-butadione, is initiated by C-C fission (1) to form two acetyl radicals which rapidly dissociate (2) to a methyl radical and CO.

CH3COCOCH3 f CH3CO + CH3CO ∆Hr,298 ) 72.9 kcal/mol

(1)

CH3CO f CH3CO ∆Hr,298 ) 11.1 kcal/mol

(2)

Thus, from each diacetyl two methyl radicals are obtained and (1) should be a clean, efficient pyrolytic source of methyl radicals at shock tube temperatures and it may be superior to some other sources we have used including ethane, acetaldehyde, and acetone. Acetone is the next easiest to dissociate of these other precursors and has a C-C bond strength that is about 10 kcal/mol higher than that of the central C-C bond in diacetyl. Consequently, diacetyl can be used for methyl generation at somewhat lower temperatures than the other precursors. Recently, we have also investigated the dissociation of CH3I as a source of methyl radicals1 and developed a mechanism for methyl radical reactions that simulates both methyl recombination and ethane pyrolysis reactions very well over the temperature range 1500-2200 K. It is likely that the experimental range that (1) is observable over will overlap the CH3I experiments providing another test for the methyl radical submechanism. * Corresponding author, [email protected]. † Chemical Sciences and Engineering Division, Argonne National Laboratory. ‡ Combustion Research Facility, Sandia National Laboratory. § Department of Chemical Engineering, University of Illinois at Chicago.

The earliest reports on the thermal decomposition of diacetyl are by Rice and Walters2 (420-470 K, 38-458 Torr) and Walters3 (383-436 K, 147-287 Torr) who studied the reaction in bulb experiments. Product analyses were performed, and a reaction mechanism proposed along with rate coefficients for (1). Subsequent thermal experiments were carried out in a stirred flow reactor (677-776 K, 0.6-45 Torr) by Hole and Mulcahy4 and in a flow tube by Scherzer and Plarre5 (822-905 K, 0.6-430 Torr). Knoll et al.6 investigated (1) in static cells (648-690 K, 43-183 Torr). The rate coefficients for reaction 1 obtained by Knoll et al., Hole and Mulcahy, and Scherzer and Plarre are in good mutual agreement. On the basis of product analyses from the above investigations, an investigation of acetone formation in diacetyl pyrolysis by Guenther et al.,7 and photochemical studies by Blacet and Bell,8,9 a reaction mechanism for the low temperature pyrolysis of diacetyl has been elucidated that satisfactorily explains the main products ketene, methane, acetone, ethane, and CO. The previous studies indicate that (1) is the sole dissociation path for diacetyl which is followed by the rapid dissociation of acetyl radicals via (2) promoting a chain reaction mechanism propagated by methyl radicals. CH3 + CH3COCOCH3 f CH4 + CH2COCOCH3

CH3 + CH3COCOCH3 f CH3COCH3 + CH3CO

(3) (4)

CH3 + CH3 f C2H6 ∆Hr,298 ) -90.2 kcal/mol

(5)

Methyl radicals attack the parent molecule via (3) and (4) and the CH2COCOCH3 radical formed in (3) readily dissociates to ketene and CH3CO. At the low temperatures of these studies methyl recombination (5) is the main termination step.

10.1021/jp903716f CCC: $40.75  2009 American Chemical Society Published on Web 07/01/2009

Dissociation of Diacetyl There are no high temperature studies of diacetyl pyrolysis in the literature, and at elevated temperatures the mechanism may be complicated by reactions of H atoms generated from secondary reactions of CH3 and dissociation of ketene. As seen from Frank et al.,10 ketene should be stable in the temperature range of the current work. The dissociation of acetyl radicals (2) is the primary source of CH3 radicals in diacetyl pyrolysis. At shock tube temperatures the only experimental value for (2) is a recent estimate by Yasunaga et al.11 which was derived from a shock tube study of acetaldehyde pyrolysis. Recommended rate coefficients for (2) also appear in compilations of kinetic data such as those of Baulch et al.12 Reaction 2 has also been the subject of three recent theoretical investigations by Huynh et al.,13 Senosiain et al.,14 and Lee and Bozzelli,15 with calculated rate coefficients covering the range 200-2500 K. Senosiain et al. estimated pressure-dependent rate coefficients that are in good agreement with the low temperature experimental results and demonstrate that dissociation of acetyl via (2) has a significantly lower barrier than other potential reactions and is the only viable route at high temperatures. The study of diacetyl dissociation and the subsequent recombination of the resulting methyl radicals is well suited to investigation by the laser schlieren, LS, shock tube, ST, technique. The measured beam deflections are proportional to the net endothermic rate and will generate large initial positive gradients from (1) followed by strong negative gradients arising mainly from methyl recombination (5). The two processes are well-separated in time as well as sign and should be clearly seen and differentiated. A theoretical investigation of the dissociation of diacetyl has also been conducted and the results were used in a Master Equation, ME, study to investigate the pressure dependency of (1). Both initial diacetyl decomposition rates and an expanded and verified mechanism for the methyl recombination reactions and the associated chain mechanism are presented here. Experimental Section The LS experiments were performed in a diaphragmless shock tube, DFST, which has been fully described elsewhere.16 The driver section of the DFST contains a fast acting valve which replaces the more traditional diaphragm. When the valve is closed by pressurizing the inside of the bellows, the driver and driven sections are separated and can be filled to the desired loading pressures. The DFST is fired by rapidly opening the valve. By variation of both the driver section pressure, P4, and the driven section pressure, P1, the pressure behind the incident shock wave, P2, can be constrained to very narrow ranges, typically