Transient Studies of Oxygen Removal Pathways and Catalytic Redox

These NO-mediated oxygen removal pathways, in which NO acts both as a .... Cristina Franch-Martí , Cristina Alonso-Escobar , Jose L. Jorda , Inma Pera...
0 downloads 0 Views 182KB Size
J. Phys. Chem. B 2002, 106, 9633-9641

9633

Transient Studies of Oxygen Removal Pathways and Catalytic Redox Cycles during NO Decomposition on Cu-ZSM5 Bjo1 rn Mode´ n, Patrick Da Costa, Deuk Ki Lee,† and Enrique Iglesia* Department of Chemical Engineering, UniVersity of California at Berkeley, Berkeley, California 94720 ReceiVed: March 15, 2002; In Final Form: June 18, 2002

The identity of reactive intermediates and of active sites and the details of redox cycles and oxygen removal pathways during NO decomposition on well-characterized Cu-ZSM5 were examined by combining previous spectroscopic and steady-state kinetic studies with measurements of the rate of evolution of NO, N2O, NO2, N2, and O2 during isothermal and nonisothermal kinetic transients. The oxygen coverages measured during reversible isothermal switches from He to NO/He mixtures showed that NO decomposition involves bimolecular reactions of two NO molecules adsorbed on vicinal Cu+ species with the formation of N2O as the initial product near ambient temperature. These vicinal Cu+ species form via oxygen removal from {Cu2+-O2--Cu2+}2+ to form {Cu+-0-Cu+}2+ using NO2 as an oxygen carrier among distant oxidized dimers. Adsorbed nitrate (NO3*) is the kinetically relevant intermediate in the formation of O2 during NO decomposition. This NO3* decomposition reaction is one of the steps involved in the equilibrated formation of NO2 observed during NO decomposition. These NO-mediated oxygen removal pathways, in which NO acts both as a reductant and as an oxidant, are significantly more rapid than recombinative desorption steps. The desorption of products and of unreacted NO during reactions of preadsorbed NO with increasing catalyst temperature confirmed the bimolecular nature and the low activation energy for N2O formation from NO. The facile nature of this reaction and the unfavorable NO adsorption thermodynamics as temperature increases combine to give the observed decrease in NO decomposition rates at high temperatures. These findings are consistent with some reported mechanism-based steady-state rate expressions and with previous infrared detection of the reaction intermediates proposed here based on isothermal and nonisothermal transients. These pathways appear to be relevant also to N2O decomposition reactions, which occur after the initial formation of N2O from NO and involve reactions of N2O with {Cu+-0-Cu+}2+ and removal of oxygen via NO-mediated desorption pathways. This study brings consensus and some clarification into the mechanistic details for NO and N2O decomposition reactions and resolves some remaining discrepancies and some contradictory conclusions in previous reports.

Introduction Direct decomposition of NO to N2 and O2 remains potentially attractive for NOx removal from combustion streams because reaction thermodynamics are favorable and no sacrificial reductants are required. Catalytic NO decomposition rates, however, are currently too low for practical use. Cu-exchanged ZSM5 zeolites are among the most active NO decomposition catalysts.1-5 Several studies have addressed the reaction pathways leading to N-N and O-O bond formation during NO decomposition on Cu-ZSM5.6-26 Cu is present in Cu-ZSM5 as divalent cations after exchange and thermal treatment in air. The predominant Cu species are isolated Cu2+ cations and {Cu2+-O2--Cu2+}2+ dimers, each interacting with two exchange sites.27 CuO particles can also form in these samples, depending on the synthesis method,6 but they were not detected in the samples used in the present study. Cu dimers have been proposed as the active species in NO decomposition.5-7 In contrast with isolated Cu2+ cations, these dimers contain a removable oxygen atom; as a result, they can * To whom correspondence should be addressed. Telephone: (510) 6429673. Fax: (510) 642-4778. E-mail: [email protected]. † Permanent address: Division of Civil and Environmental Engineering, Kwangju University, Kwangju 503-703, Korea.

undergo the redox cycles implicated in NO decomposition turnovers. We have previously reported steady-state kinetic rate data for NO decomposition and a consistent set of elementary steps.26 These elementary steps replace previously proposed oxygen removal pathways, which require recombinative desorption of nonvicinal oxygens, with a catalytic NO-NO2 cycle that forms O2 using oxygen atoms in nonvicinal {Cu2+-O2--Cu2+}2+ dimers. This catalytic sequence accounts for the unusual decrease in NO decomposition rates observed above 773 K.3,8,26 At lower temperatures, O2 inhibits NO decomposition rates because of competitive adsorption of oxygen and NO on reduced Cu+ sites. This inhibition leads to the normal Arrhenius behavior prevalent below 773 K. At these temperatures, O2 inhibition effects become less severe, {Cu+-0-Cu+}2+ species become the most abundant surface intermediates, and the adsorption of NO on such species becomes thermodynamically unfavored. This leads to the decrease in NO decomposition rates observed at higher temperatures. Isothermal transient studies of NO decomposition on CuZSM5 have been previously reported.9-12 In these measurements, an inert flow is replaced with a stream containing NO. N2 formation rates are initially high, but they decrease as the system approaches steady state.9-11 O2 evolution rates are

10.1021/jp020731g CCC: $22.00 © 2002 American Chemical Society Published on Web 08/27/2002

9634 J. Phys. Chem. B, Vol. 106, No. 37, 2002

Mode´n et al.

TABLE 1: Elemental Composition and Cu Speciation Cu(0.36) Cu (wt %) Si/Al Cudimer/Cutotalb

2.25 14.0 0.56

a

Cu(0.58)

Cu(0.60)

3.31 15.0 0.70

3.88 14.0 0.78

a Atomic Cu/Al ratio. b Measured from the CO2 produced during COTPR after O2 treatment.27

initially lower than N2 formation rates, but they increase to the equimolar reaction stoichiometry at steady state. The subsequent removal of NO from an inert stream leads to initial O2 evolution rates exceeding those measured during steady-state NO decomposition. This has led to the proposal that NO stabilizes adsorbed oxygen in the form of a Cu2+(O)(NO)(NO2) species.11 In situ infrared studies coupled with mass spectrometry have been used to detect adsorbed species during isothermal NO transients.12 The introduction of NO at 673 K led to the immediate appearance of a band assigned to Cu+(NO), and then to a band for bridging Cu2+-(NO3-)-Cu2+.12 These were the only infrared bands detected at 673 K. Infrared studies have also confirmed that NO adsorbs on Cu+ 5,13-18 and suggested that Cu+/Cu2+ redox reactions occur as conditions change from reducing to oxidizing.19 NO decomposition appears to occur via the initial formation of N2O followed by its decomposition.26 N2O and small amounts of N2 are typically detected during temperature-programmed desorption of preadsorbed NO on Cu-ZSM5.10,12,20-23 Two low-temperature N2O desorption peaks and one O2 evolution peak at higher temperatures have been detected along with broader NO desorption peaks over a wide range of temperature (300-750 K).20 Oxidation of the sample before NO adsorption markedly decreased the amount of N2O formed.20 Here, we report isothermal and nonisothermal transient experiments carried out in the presence and absence of NO in the carrier gas in order to confirm the details of the elementary steps proposed previously based on steady-state kinetic data.26 These experiments are then brought together with these steadystate kinetic data and with detailed structural characterization and reduction studies of the Cu species in these materials.27 We conclude with a model of the site requirements and the mechanism of NO decomposition on Cu-ZSM5. Experimental Methods Catalyst Synthesis and Characterization. The synthesis of the Cu-ZSM5 catalysts and the characterization of their structure and reduction properties have been described in detail elsewhere.27 Elemental analyses are shown in Table 1 for all catalysts used in this study. All samples are denoted as Cu(x), where x is the atomic Cu/Al ratio. The Cudimer/Cutotal ratio represents the fraction of the total Cu atoms that are present in Cu dimers. Reactant and Treatment Gas Mixtures. The NO-containing stream contained 1.00% NO, 9.98% Ar, and 89.02% He (Matheson;