Volumetric Quantitative Determination of--SOONa Group in Sodium

Volumetric Quantitative Determination of--SOONa Group in Sodium Benzene Sulfinate ... Critical Study of Different Methods for Determination of Chlorit...
2 downloads 0 Views 288KB Size
Volumetric Quantitative Determination OF - S O O N a in Sodium Benzene SulFinate

Group

LEO ACKERMAN, Analytical Section, Process Development Department, General Aniline & Film Corporation, Grasselli, N. J.

T

HE quantitative precipitation of aryl sulfinic acids as ferric salts, reported in 1909 by Thomas ( 3 ) ,has been employed in a variety of procedures as the principal reaction in the quantitative determination of the sulfinic acids. Thomas mentioned the formation of sulfonyl chlorides, by reactmionwith sodium hypochlorite in sodium carbonate solution, but apparently made no attempt to use this react'ion as a quantit'ative tool. Krishna and Singh ( 2 ) reported using the ferric salt reaction, employing a solution of ferric chloride of predetermined concentration, fiitrring off the ferric salt, and determining the excess of ferric chloride. Until recently, Thomas' ferric salt reaction in very Concentrated solution has been employed in this laboratory, for want of a better method.

The approximate equivalent of 2.5 grams of sodium benzene wlfinate is dissolved in 25 ml. of distilled water, and made acid t o Congo red b y dropwise addition of concentrated hydrochloric acid. Fifteen milliliters of 1.5% ferric chloride solution are added and the resultant slurry is swirled for several minutes until the precipitate turns light yellow. The precipitate is filtered and washed 6 times with 5 ml. of water, and 3 times with 5 ml. of methanol, care being taken to fill in the cracks which form on the filter. The precipitate is then removed to a large crucible (5 v~ii.)and carefully ignited t o Fe20a. Thcre are disadvantages in using this procedure. The ferric salt is soluble in excess ferric chloride. The precipitate is so voluminous that it is very difficult and time-consuming to wash it free of salts, and the mass on the filter nearly alJvays cracks. Sodium sulfite, known to be present in commercial sodium benzene sulfinate, interferes with the accuracy of the method. Comparative runs on equal samples have also shown that the weight of precipitat,e becomes less as the initial concentration of sodium benzene sulfinate is reduced. These objections also apply to the Krishna and Singh method in its application to commercial production. Krishna and Das ( 1 ) report a complex gas volumetric analysis involving the liberation of iodine from a mixture of potassium iodide and pot,assium iodate, and utilization of the free iodine t o liberate oxygen from hydrogen peroxide. The success of this method, by admission of the authors, depends on the high purity of the reagents and also on an approximate adjustment of the proportions in which they are used. These prerequisites, in addition to the complexity of the procedure, seem to disqualify i t as a simple method. Thomas' reaction of sodium benzene sulfinate with sodium hypochlorite was investigated and found to give accurate and reproducible results. When sodium benzene sulfinate with only slight excess of sodium carbonate was treated with concentrated (12%) sodium hypochlorite, a small yield of sulfonyl chloride was obtained. However, under the conditions employed in the method described below, t h e reaction is probably CeHSS02Na NaOCl +CoH5S0aNa NaC1 Even if some sulfonyl chloride is formed, the equation CaH5SOzNa SaOCl H20---f CeH6SO2C1 2NaOH still gives the same molecular proportions to the reaction as the first equation. Ch1orat)es present in the sodium hypochlorite solution used presented no problem, since they do not react, with the sulfinate and may still be detected after completion of the oxidation. TESTPAPER.The starch-iodide t,est paper used in the procedure described here must be very sensitive. The following formula, used in this laboratory, was found satisfactory:

+

+

One liter of distilled water is boiled several minutes, and 3 grams of pure cadmium iodide crystals are added to it, followed by 5 grams of potato starch which have Been made into a thin paste with water. The mixture is boiled for several minutes, It is allowed to settle for at, least 24 hours, and the clear liquor is decanted. Then strips of Reeves-Angel filter paper No. 211, about 12.5 cm. (5 inches) wide, are passed through the solution and dried in a relatively dust-free atmosphere, away from fumes. The strips are cut into thin strips 1.23X 12.5 cm. (05x5 inches). PROCEDURE

A sample, S , equivalent to approximately 2.5 grams of sodium benzene sulfinate is accurately weighed and transferred to a 250ml. Erlenmeyer flask, diluted to approximately 150 ml. with distilled water, and made slightly alkaline with dilute sodium hydroxide solution, using a very small spot on brilliant yellow paper as an indicator. Ten milliliters of 10% barium chloride solution are added and the precipitate of barium sulfite (and barium sulfate) is allowed to digest for 0.5 hour on a steam bath. The solution is then filtered, washed directly into a 250-ml. volumetric flask, and made to the mark at room temperature (Sjlution -4). Twenty milliliters of about 12% sodium hypochlorite solution are diluted to approximately 1 liter (Solution B). Fifty milliliters of this solution are titrated with standard 0.1 N sodium arsenite solution until the blue spot which first appears on starchcadmium iodide test paper when touched by a drop of the solution ceases entirely to show. (This standardization of solution B must be repeated if the latter IS to be used aft,er several hours' standing.) Titrat'ion = b. Fifty milliliters of solution €3, 50 ml. of 10% sodium carbonate solution, and 100 ml. of distilled water are cooled to about 15' C. Into this solution, solution A is run from a buret until a blue spot ceases entirely to appear, as above. Titration = s. CALCULITIOX

0'016416 loo 2X&-)XS -. -

= %sodium benzenesulfinste

EXPERIMENTAL

A good grade of sodium benzene sulfinate was recrystallized three times from water. The crystals obtained were dried over sulfuric acid in vacuum for 36 hours, then dried a t 100' C. in air for 1 hour. The resultant compound was analyzed and found to contain S, 19.51%; C 44.00%; H, 3.13%. Calculated: 8, 19.52%; C, 43.89%; 3.07%.

k,

This material was analyzed with the results shown in Table I. To test further the relative values of the two procedures for commercial application, a mixture of the pure sodium benzene sulfinate with the inorganic salts usually found in the technical product, and sodium benzene sulfonate, a possible impurity, WBB

Table

1.

Analysis of Sodium Benzene Sulfinate Proposed Method Ferric Salt Method

% 1st 2nd 3rd 4th 5th 6th

+

+

"",j;

+

%

. 100.24 100.10 100.10

run run run run run run

243

run run run run run

.. .. ..

II. Analysis of Mixture Proposed Method

1st run

95.94

99.97 99.97 100.11

Table

2nd 3rd 4th 5th 6th

99.66

100.43

Ferric Salt Method

%

%

80.26 79.89 80.18 80.18 80.09 80.18

89.3 98.3 94.4

... . ..

INDUSTRIAL AND ENGINEERING CHEMISTRY

244

prepared. This combination was thoroughly ground and mixed to ensure homogeneity. Content of the mixture follows: . NaCl KazS04

Grama 2.5000 2 5000

Grams NazSOa CeHsSOsNa

CsHsSOzNa

2 5000 2.5000

Grams 40 0000

An analysis of the mixture containing 80.0070 sodium benzene sulfinate gave the results shown in Table 11. ' ACKNOWLEDGMENT

The author is duly grateful to J. Werner for guidance, and to

Vol. 18, No. 4

P. Kawiasky and R. H. Zappert for cooperation and constructive criticism. Thanks are extended to H. Ill. Schramm for the sulfur determination, and L. T. Hallett for the carban and hydrogen determinations. LITERATURE CITED

(1) Krishna, S., and Das, Bhagwan, Quart. J . Indian Chem. Soc., 4, 367-74 ( 1 9 2 i ) . (2) Krishna, S., and Singh, Harnani, J . Am. Chem. Sac., 50, 792-8 (1928). (3) Thomas, J., J . Chem. SOC.,95, 342-5 (1909)

Determination of Ipropylene Glycol in Ethylene Glycol R. C. REINKE

AND

E.

N. LUCE,

The Dow Chemical Company, Midland, M i c h .

A

procedure for the determination of I,I-propylene glycol in the presence of ethylene glycol consists of a periodate oxidation of 1,I-propylene glycol to acetaldehyde and formaldehyde and of ethylene glycol to formaldehyde, and the separation of the t w o aldehydes b y a blowing-out process, forming the acetaldehyde sulfite addition compound which is titrated with iodine. By this method it is possible to determine 9870 of the 1 ,I-propylene glycol present over a range of 0 to 90% 1,I-propylene glycol in ethylene glycol. A method for determining total glycols b y periodate i s also given.

A

METHOD was desired for the determination of l,2-propylene glycol in ethylene glycol, in varying amounts and in various types of samples. Fractionation procedures were impractical, since they required too much time and did not easily permit analytical separation because of the small difference in boiling points. Furthermore, this type of method would not be satisfactory A-hen dilute aqueous solutions mere encountered. A search of the literature revealed much u-ork on this problem, but none suitable to the authors' needs. Hoepe and Treadwell (4)developed a method for the quantitative determination of glycerol, ethylene glycol, and 1,2-propylene glycol involving periodate oxidation of the alcohols and depending on accurate determination by the potassium cyanide method of formaldehyde in the presence of acetaldehyde. The authors found this procedure unsuitable, owing to interference of the acetaldehyde. I n a method for determining small amounts of lactic acid in blood and urine, developed by Clausen ( I ) , the lactic acid was oxidized to acetaldehyde which was removed by an aeration process from the other oxidized materials. Kicolet and Shinn (6) ,determined methyl pentose in the presence of pentoses by a periodate oxidation and separation of aldehydes by aeration. As the basis for the present work Shupe's (7) micro application of the Nicolet and Shinn procedure to glycols in cosmetic ingredients was used. Changes in design of equipment and procedure were made to ensure theoretical results in the type samples encountered. OUTLINE

The oxidation of glycerol by the periodate method of Malaprade ( 5 ) , Fleury and FatBme (3) and adaptation t o glycols by Denice (2) may be expressed as follows:

+

+ +

+

CZHa(OH)z HI04 --f 2CHzO HIOs Hz0 CH3CHOHCHzOH HI04 --f CHzO CHsCHO HIOs

+

+

+ Hz0

The ethylene glycol yields two molecules of formaldehyde, while the 1,2-propylene glycol reacts to give one molecule each of formaldehyde and acetaldehyde. The aldehydes are separated by blowing them through a saturated solution of sodium bicarbonate containing a definite quantity of glycine. This treatment removes the formaldehyde, and the acetald_ehyde is then deter- mined by the sodium bisulfite procedure:

HCHO

+ NHzCHzCOOH --+ CHzSCHzCOOH + Hz0 OH CH3CH0

/

+ hTaHSO3--+-CH3C-S03iYa \ H

2NaHS03

+ 212 + 2HzO

--f

4HI

+ HzSO4 + SanSO4

The sulfite solution containing the absorbed acetaldehyde is treated n-ith iodine to remove excess sulfite and then made alkaline xith saturated sodium bicarbonate n.hich destroys the addition compound. The sulfite thus liberated is titrated with a standard iodine solution with a buffer added just before the end point. REAGENTS

PERIODIC ACID, 0.1 JI. IVeigh 10.7 grams of sodium metaperiodate into a 500-ml. volumetric flask, and add 200 ml. of water followed by 100 ml. of 1 N sulfuric acid. Dilute the solution to volume with distilled water and shake the flask until solution is complete. IODIXE, standard 0.1 W . IODIXE, standard 0.02 N. Dissolve 30 grams of potassium iodide in 100 ml. of water in a 500-ml. volumetric flask and measure in accurately from a buret 100 ml. of standard 0.1 N iodine. hlake to volume with distilled water. IODINE, approximately 0.1 N. SoDIunr BISULFITE, 5%. Dissolve 5 grams of sodium bisulfite in 100 ml. of water. BUFFER (Borax-sodium carbonate mixture). Dissolve 4 grams of borax (KazB,O,. 10H20) and 5 grams of anhydrous sodium carbonate'in I00 ml. of water. GLXINE (aminoacetic acid). Dissolve 5 grams of U.S.P. glycine in saturated sodium bicarbonate solution and dilute to 250-ml. volume with saturated sodium bicarbonate solution. STARCH.Dissolve 0.5 gram of soluble starch in 10 ml. of cold water and add to 90 ml. of boiling water. Boil 5 minutes and cool. SoDIrir BICARBOKATE, Li.s.P. pon-der. SoDIuhr BICARBONATE, saturated aqueous solution. SODIUM ARSENITE, standard 0.1 N . PoTAssIu~rIODIDE, approximately 10%. I

APPARATUS

Special equipment used in determining 1,2-propylene glycol consisted of: CARBON DIOXIDEOR NITROGEN, one cylinder. FLOWMETER, calibrated for 1.5 liters of carbon dioxide per minute. REACTION AND SORPTION TUBES.The equipment consists of a series of 4 test tubes connected in a manner satisfactory for passing gas through the solutions. The first tube (200 X 29 mm.) is fitted with a 3-hole rubber stopper carrying a small separatory funnel through which the sample aliquot and periodate solutions are added. This funnel also serves as an inlet tube for carbon dioxide. A large-bore glass tube, also inserted in the stopper of the first tube, is dividkd above the stopper by a piece of rubber tubing. I t serves as a reservoir and inlet for the sodium